Models > 1305002

1305002 Whirlpool

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for 1305002

Viewing 1 of 1
Keep searches simple, eg. "belt" or "pump".
This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...
In Stock
This is an OEM part sourced directly from the manufacturer. This white silicone adhesive caulk is commonly used on ranges, microwaves, and cooktops. This adhesive sealant works to form a bond between ...
In Stock
This is a ceramic fuse for a microwave. It is just over 1 inch long. This fuse is 20 amps and 250 volts. This part powers your microwave. If your appliance is not heating properly, or is not turning o...
In Stock
$9.56
Part may differ in appearance, but functions same as original.
In Stock
No Longer Available
No Longer Available
No Longer Available
No Longer Available
No Longer Available
No Longer Available
No Longer Available
No Longer Available

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Problems and Symptoms for 1305002

Viewing 2 of 2
Leaking
Fixed by these parts
Fixing
How to fix it
Won’t turn on
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
tad from tamarack, MN
Parts Used:
WPM0805101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
microwave oven blew fuse
First I removed upper front grill by removing two Philips head screws on top and pulling off. This exposed the Philips head screw which holds control panel in place. After removing screw I pushed up on panel and it came off to expose fuse. With needle nose pliers I removed old fuse and again with pliers held new fuse in position. With th e help of a bladed screwdriver, I pushed new fuse into holder, then replaced panel, screw and grill. This took less than 15 minutes even as one of the wires on control panel pulled out of connection and took some time to locate where to reconnect, otherwise was an easy fix
.
24 of 37 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Denice from Montgomery, AL
Parts Used:
WPM0805101
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
microve stopped working
Jenn-Air Microwave would not turn on. Clock worked , light worked, timer worked and would count down .I changed' Part #0813140 Switch, Micr} cost $8.99 plus shippingNow it works Thank You for good advise
12 of 22 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
connie from madison, NC
Parts Used:
WPM0805101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Died while heating lasagna
Removed 4 small star head screws from back of microwave, lifted body off, removed blown fuse and replaced with new one (found where cord enters). This model is stainless inside and out and I like it a lot. It is also sold by Daewoo and a few other manufacturers.
9 of 15 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!