Models
>
WF350ANP
WF350ANP Samsung Washer
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
On Order
In Stock
Order now and your part arrives by Jul 24
In Stock
Order now and your part arrives by Jul 24
In Stock
Order now and your part arrives by Jul 24
In Stock
Order now and your part arrives by Jul 24
In Stock
Order now and your part arrives by Jul 24
$40.69
This oil seal (part number DC62-00223A) is for washers. Oil seal DC62-00223A presses into the rear drum to prevent oil from leaking past the basket spin shaft. Unplug the appliance before installing t...
In Stock
Order now and your part arrives by Jul 24
In Stock
Order now and your part arrives by Jul 24
On Order
$48.95
The thermistor monitors and helps regulator the water temperature in the washer.
In Stock
Order now and your part arrives by Jul 24
In Stock
Order now and your part arrives by Jul 24
The pressure switch senses and controls the water level in the washer.
In Stock
Order now and your part arrives by Jul 24
Common Problems and Symptoms for WF350ANP
Viewing 1 of 1
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Helen from NASHUA, NH
- Parts Used:
- WP89503
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Leaking water inlet hoses.
Removed the old hoses and screwed on the new hoses.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from Leesburg, FL
- Parts Used:
- DC67-00244A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The drain hose disappeared.
The new hose arrived without a plug, so I found a golf tee that fit securely.
I put a few drops of dish soap on the machine end and it slid on with a little resistance.
I ran a few light cycles, and the leak has stopped.
Thank you
I put a few drops of dish soap on the machine end and it slid on with a little resistance.
I ran a few light cycles, and the leak has stopped.
Thank you
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jimmy from MEMPHIS, TN
- Parts Used:
- WP89503
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Old hot water inlet hose had budge at both ends.
Turn water off at the inlet valve of hose you are replacing. Disconnect inlet hose the washer and let water drain out in a bucket. Then remove old hose. Replace new hose to inlet valve then washer . Use pliers to tighten both ends. Turn on water to check leaks at both ends of hose.
Was this instruction helpful to you?
Thank you for voting!