WF45K6500AV ((A2-00)) Samsung Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Samuel from NEEDVILLE, TX
- Parts Used:
- DC60-40137A
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Nutdriver, Screw drivers, Socket set, Wrench set
Washer making noise a snow smoking.
Take pics every step, easier re-assembly. Dismantled washer keeping bolt/screw section removed compartmentalized in a tackle box in the order of removal. Replaced drum support, bearings, seal, old blots. Too much to write but I was able to do it all in about 4 hours once all the parts finally came in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gumecindo from SALINAS, CA
- Parts Used:
- DC97-16140N
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers
Water leak from torn front diaphragm
Unplug electrical cord. Remove top of washer. Remove soap dispenser tray. Remove control panel, disconnect electrical harness from back of panel.
Remove front door assembly, make sure you first remove the wire clamp from the front of the diaphragm. Remove hoses from diaphragm and then remove the rear wire clamp on the diaphragm. Install the new diaphragm by starting at the bottom and make sure the drain holes line up. Assemble everything back in reverse order of how it was disassembled.
Remove front door assembly, make sure you first remove the wire clamp from the front of the diaphragm. Remove hoses from diaphragm and then remove the rear wire clamp on the diaphragm. Install the new diaphragm by starting at the bottom and make sure the drain holes line up. Assemble everything back in reverse order of how it was disassembled.
Was this instruction helpful to you?
Thank you for voting!