WF409ANR Samsung Washer

An initial issue was getting the door to unlock. I tired several things but finally was able to pull the door as if to open it and put something between the door handle and the front of the washer while I ran a washer cycle. There is a way to take the washer top off and reach down inside the unit and pull down on a release, but I did no ... Read more t try that.

The washer has a rubber boot between the washer frame and the wash tub. There is a metal wire ring that secures the outer edge of the boot to the washer frame. Peel back the outer edge of the boot at the bottom to reveal a metal ring that has its ends connected by a small spring. Use a flat tip screw drive to pry this ring off. Peel back the boot from the washer frame.

Next use a Phillips screw drive to remove the two screws that protrude through the wash frame on the right side of the door.

Reach between the washer tub and the frame and the tub and pull the switch through the opening and the washer tub. You will have to wiggle the switch around to remove it. There are three sets of wires attached to the switch by plugs.

The switch is covered with a plastic protective cover. Remove this. You will have to use a screw driver to release various catches to do this.

Remove the three set of wires. There are catches that secure the wire plugs in place. pry them back with a small screw drive.

Attach the new switch to the sets of wires.

Attach the protective cover to the switch. The wires feed through a small slot toward the bottom of the switch.

Slide the switch through the opening where you removed it. and re-attach it using the two screws.

Put the rubber boot in the channel in the washer frame. Replace the metal ring. This was the most challenging part of the repair for me. I had to play around with this to get it into position. You have to work it around the gasket and stretch out the spring.

By the way, The service was great and exceeded by expectations.

Removed the old hoses and screwed on the new hoses.

Turn water off at the inlet valve of hose you are replacing. Disconnect inlet hose the washer and let water drain out in a bucket. Then remove old hose. Replace new hose to inlet valve then washer . Use pliers to tighten both ends. Turn on water to check leaks at both ends of hose.