11020112311 Kenmore Washer - Parts

Commonly referred to as dog ears, these agitator directional cogs are manufacturer approved replacement parts that come in a package of 4 and are usually used with direct drive washing machines. We re...

Also known as an O-Ring. This black o-ring seal is three inches in diameter.

The washer drive pulley kit is also known as a replacement clutch assembly, or a cam kit. The drive pulley is found at the bottom of your washing machine, mounted to the drive shaft. Common symptoms i...

The drive belt works with the pulley in your washer in order to spin the tub. If you notice a burning rubber smell, your washer has become excessively noisy, or it will not spin, it could indicate an ...

The O-Ring is included with this cap. It can be purchased separately as Part #WPW10072840.

This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...

If your washer shakes or makes loud noises during a cycle, this suspension rod kit could help. It comes with four rods that keep the tub steady and reduce movement. Easy to install and compatible with...

This part goes on the agitator retaining bolt.

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

This insert is sold individually. Knob not included. Knob is sold separately.

This hose clamp is sold individually.

This shift actuator plays a key role in the operation of your washing machine by controlling the transition between spin and agitate modes. It also relays spin speed information to the control board, ...