Models
>
GWX4070S*119
GWX4070S*119 General Electric Washer
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for GWX4070S*119
Viewing 2 of 2
Keep searches simple, eg. "belt" or "pump".
$15.26
This plastic clip is a genuine OEM part, used to help connect the timer knob to the shaft on your washer. If the clip has become damaged it will need to be replaced. The clip is found on the backside ...
In Stock
Order now and your part arrives by Jul 30
This part is the replacement timer knob for your washer. It is made of white plastic and is about 1 ¼ inches in diameter. The timer knob sits on the timer shaft and allows you to choose the wash cycle...
No Longer Available
This compression ring works in conjunction with the timer dial.
No Longer Available
Special Order
In Stock
Order now and your part arrives by Jul 30
This Includes 1 boot seal that measures approximately 12? in diameter.
No Longer Available
Special Order
Common Problems and Symptoms for GWX4070S*119
Viewing 3 of 3Will Not Start
Fixed by these parts
How to fix it
Leaking
Fixed by these parts
How to fix it
Touchpad does not respond
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- DANIEL from ROLLING MEADOWS, IL
- Parts Used:
- WH1X2757
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Timer would not turn. The knob was slipping.
I went to your web suite to get part numbers. Found your videos. It told me what my problem was and how to fix it. Pull clip off. install new knob reinstall clip done. Very easy and fast. I couldn't even get a repairman out that fast.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- bob from forestdale, MA
- Parts Used:
- WH1X2757
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Knob would not advance timer / cycle selector.
After pulling the knob out ( on position) a white retainer clip was visible behind the knob. Using a paper clip bent in to a "J" shape I was able to easily remove the retainer clip and knob . The old knob had several stripped teeth that caused the problem. The new knob came with the retainer clip installed . The knob slipped on and locke
... Read more
d in position.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jason from Colwich, KS
- Parts Used:
- WH08X10018
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers, Socket set
Started leaking from boot edge
Popped the top by pushing in front clips with screwdrivers. Removed spin shield. Removed agitator and hub cover (all by hand). Used 12pt. socket to remove three bolts holding the tub. Pulled up tub (difficult b/c of weight and slippery residue). Loosened clamps w/ nutdriver and removed boot. Scrubbed clamps clean and reinstalled eve
... Read more
rything.
Forgot to get clamps really snug, so it dripped a little. Did everything second time, but before replacing tub, did a leak check by running a load. Worked great. Good luck.
Forgot to get clamps really snug, so it dripped a little. Did everything second time, but before replacing tub, did a leak check by running a load. Worked great. Good luck.
Read less
Was this instruction helpful to you?
Thank you for voting!