GFWR2700H1WW General Electric Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- John from LYONS, CO
- Parts Used:
- WH23X10051
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers
Drain pump failed
Remove back cover and with a light and a mirror the screws can be identified. Three hold this pump on. Remove electrical connection then the pump. So also remove the corrugated connecting boot by undoing three clamps. Clean and reassemble
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Raymond from LAS VEGAS, NV
- Parts Used:
- WH47X10043, WH47X10033, WH02X10395, WE19M10949
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Soap dispenser door grommet was over tightened by factory
Plastic welded grommet holder and inserted screw and gromment. Then I placed the badge on the door and inserted the latch.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Linda from Miami, FL
- Parts Used:
- WH01X10727
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- 1- 2 hours
Washer was vibrating during spin cycle
Problem got worse the technician installed the damper assembly but the problem got worse . The machine sounds like a tractor .
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rodney from NEW BALTIMORE, MI
- Parts Used:
- WH45X10137
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Socket set
Water leakage, inner basket bearing play, motor not running
Replaced outer drum, both halves, inner basket/trunnion assy. , Fan housing from excessive vibration/broken mount tabs. Used multimeter to test rotor position sensor ohms, replaced sensor, machine operating as new now.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Regis from SAN MARTIN, CA
- Parts Used:
- WH45X10138
- Difficulty Level:
- Easy
- Total Repair Time:
- More than 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers, Socket set
TUB OUT OF BALANCE
Replaced the balance ring on the tub but the main tub was cracked and could not be repaired.
Parts select was very helpful. Sent me instructions to repair the washer and replaced defective parts from shipping within 2 days. VERY GOOD EXPERIENCE
Parts select was very helpful. Sent me instructions to repair the washer and replaced defective parts from shipping within 2 days. VERY GOOD EXPERIENCE
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Fernando from Chester, NY
- Parts Used:
- PM14X10005
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Wrench (Adjustable)
Needed to change old hoses-7 years old.
Had to shut off the water valves and move the washer.
Needed the wrench because the old hoses were tight. Only tightened the new hoses a little with the wrench.
Needed the wrench because the old hoses were tight. Only tightened the new hoses a little with the wrench.
Was this instruction helpful to you?
Thank you for voting!