WWA8314PKLWH General Electric Washer

First cut off both incoming water supplys. Next remove the water hoses to the inlet. Then remove some of the screws that are holding the back panel on that will give you access to the inlet plate remove those screws and that are holding the inlet in. when you remove the inlet mark the wires take of the water hose and remove inlet now do t ... Read more he opposite to assemble There was no Rocket Scientist needed and the funny part $12. cheaper than literally going around the corner to the appliance store Thank You and my wife thanks You

I pulled out machine turned off the water ,and unpluged the machine. Took off the hot and cold water hoses with help of vise grips. Next the two nuts which hold's the part to the machine(plate) and the nut that holds the part to the plate pulled out the part marked the four wires which go onto the part undid clamp on hose and pulled off ... Read more hose. put the hose on new part , re-attached the wires , put part on plate and attached plate and part to machine hooked up hoses turned on water and plugged in machine . The washer does not leak and works great. I'm a 59 year old woman.

Replacing the inlet valve could not have been any easier. First, I removed the back plate of the washer using a socket wrench on the 2 screws. After removing the wiring attached to the valve, I then detached the valve from the plate with the same socket wrench.

I then loosened the clasp on the rubber hose and disconnected it ... Read more from the valve.

I replaced the new valve using exactly the same procedure, only in reverse. First attached the hose, the attached the valve to the back plate. Then replaced the back plate on the washing machine and reattached the hoses.