GUD24ESSM0WW General Electric Washer Dryer Combo - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Thomas from RICHMOND, CA
- Parts Used:
- WE12X27300
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
Socks dropping outside of the drum into the bottom caused the drive belt to come off.
I put the old belt back on but it came off after a couple of washing. I had ordered a new one. Trouble was the new belt would work its way off the large smooth wheel as I turned the motor pully to get the belt on. Solution: I taped up a stack of shims to fit between the washer bottom and the back, bottom of the smooth, drum wheel. This stopped the drive belt from rotating off as I turned the motor pully. Success. You're laying on your side, on the floor, with minimum room under the drum and lots of sharp edges.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steven from PHILADELPHIA, PA
- Parts Used:
- WH44X27239
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Lower drum spline failure unstable replaced and just a snap on to the outer tank.
After drum replacement just clips to snap on outer tub then assembled front cross support, top lid unite and front panel.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William from GORDONSVILLE, VA
- Parts Used:
- WH18X27241
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Turn knob was broken during move.
Remove 2 screws on each side of panel and two screws inside dryer door threshold. Remove the old assembly by turning the switches. Insert new assembly, rotate each switch to secure.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- NURI from NESCONSET, NY
- Parts Used:
- WE04X27284
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Washer machine was not powering up!!!! No LED indicators was coming on!!!
Un plugged the unit, installed new UI board, powered up and used the machine, All functions back to normal, All along I never loose the dryer worked all the time before and after replacing the UI main board,, it was strange!!!!
Was this instruction helpful to you?
Thank you for voting!