Models
>
WSM2780WAWWW
WSM2780WAWWW General Electric Washer Dryer Combo
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for WSM2780WAWWW
Viewing 6 of 6
Keep searches simple, eg. "belt" or "pump".
This is the replacement lint filter for your dryer. The lint filter traps unwanted lint and debris so your dryer can effectively dry your clothes.
No Longer Available
In Stock
Order now and your part arrives by Jul 23
Bearing Only. This part helps your appliance run as quietly as possible.
No Longer Available
$25.10
This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.
In Stock
Order now and your part arrives by Jul 23
Special Order
This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.
No Longer Available
In Stock
Order now and your part arrives by Jul 23
This dryer solenoid kit comes with both the 2 and 3 wire coil valves.
No Longer Available
Common Problems and Symptoms for WSM2780WAWWW
Viewing 4 of 4Noisy
Fixed by these parts
How to fix it
Leaking
Fixed by these parts
How to fix it
Will not agitate
Fixed by these parts
How to fix it
Will not drain
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Jack from Canyon Lake, TX
- Parts Used:
- WH23X10041
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers
Washer would not drain
Removed 2 Hose clamps with pliers. Unplug power source from drain pump. Unscrew 2 mounting screws with 5/16" nut-driver then replace unit in reverse sequence...... Very simple.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Patricia from chicago, IL
- Parts Used:
- WE16X29397
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
filter had a hole
simple replacement
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dave from Salt Lake City, UT
- Parts Used:
- WE01X10160
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Control knob had broken and we were unable to set the dryer
I first ordered the replacement knob. It had broken before and I had repaired using a steel washer and epoxy to support the cracked plastic. When the support system I installed broke, I suspected a deeper problem; increased resistance to knob rotation in the control system. I removed the front panel to get back at the switch area. I
... Read more
wanted to lubricate the whole control, but UT seemed to be well sealed. Finding a couple areas where the plastic came together, held by a permanent metal mount, I used a pressurized silicone lubricant and sprayed into the small spaces. That allowed for easier rotation of the control, hopefully giving a longer lifespan to the new knob. DO
Read less
Was this instruction helpful to you?
Thank you for voting!