FGB24T3ECD Frigidaire Wall Oven - Instructions

Turned power off at electrical panel. Pulled oven away from wall. Removed back cover (6 screws), then unplugged wires from old receptacle. I had to pull the squeeze clips backwards & break them to remove the old receptacle - couldn't squeeze them enough to remove them otherwise. The old receptacle came out through the inside of the oven, and the new one snapped in easily from inside the oven as well. Replaced wiring, installed new bulb, restored power & tested. Replaced back cover. Good time to vacuum under/behind where the oven usually lives before sliding it back to the wall.

Twisted replacement bulb into place easily. Let there be light!

I replaced the bulb using my hands to twist the bulb in the socket located at the top of the refrigerator.

The bulb has a plastic clear cover. That cover can just be carefully removed using a screwdriver. It's held in by a metal bracket. After you remove the cover. You'll just need to replace the bulb and then re-install the cover and bracket.

moved the stove forward and removed old cord by uncruing two small screw and on ploged the all and replaced with the new one.

Installed only with bare hands in 20 minutes.

replaced it

Just compressed the circular part to insert it in place. Already melted & will not function again with use of the oven; cannot turn off the oven with this knob. Need to find a safer substitute for this knob. I took it out again and am using the eraser end of a pencil to turn off my oven. At least it is easy to take out; it could be melted to the control panel. It is all in how you look at the situation...might as well laugh since I can eventually turn off the oven.

Easy repair. I simply removed the upper screws and removed the panel that the clock/timer was attached to. The switch for the oven light is also attached to that panel so to avoid a shock when you remove the wires from the switch you need to shut the power off to the oven. I unplugged the wires from the switch and the timer and laid the panel on the table. I removed the 4 screws that held the clock/timer to the panel and installed the new one in its place. Reassembled everything in the reverse order and turned the power back on. The repair was successful and evrything works well.

I was replacing a range oven hood, so I pulled the oven away from the wall but left it plugged in. I removed the old oven hood, which had an exhaust pipe that was still mounted through the cupboard. While I was preparing the new oven hood the exhaust pipe fell out of the cupboard and cut the oven wire in half. I was able to find the part number on the existing cord and looked up on line. I ordered the part using 3-5 business days and it showed up in 2 days. I was able to attach the new cord, which had an easy clip plug, and secure back to the stove. Very easy and very inexpensive to do.