Models
>
W25SB
W25SB Weed Eater Trimmer
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for W25SB
Viewing 3 of 3Keep searches simple, eg. "belt" or "pump".
$4.99
This fuel filter is for lawn and garden equipment engines.
Fuel filter cleans the fuel before it reaches the carburetor.
Work in a well-ventilated area when installing this part. Drain the fuel...
In Stock
This is a spark plug for your lawn equipment. This part ignites the air and fuel mixture in the cylinder of the engine to power your machine. If the tip of the spark plug is burnt out or damaged it is...
No Longer Available
$17.43
This fuel tank is for lawn and garden equipment engines.
Fuel tank holds the gas that's needed by the engine.
Work in a well-ventilated area when installing this part. Drain the existing fuel f...
In Stock
On Order
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for W25SB
Viewing 2 of 2Will Not Start
Fixed by these parts
How to fix it
Engine stops after a few seconds or minutes
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Rosanne from BRIDGEWATER, VA
- Parts Used:
- 545227901
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
Clogged muffler
Remove the 4 screws holding the rear motor casing. Then you can take the easy route and drill through the front motor housing with a 3/8 to 1/2 bit in order to access the front muffler screw. If you want to work harder you must remove the motor from the shaft, remove the clutch assembly (this requires a long 15t torx bit, removing the spa
... Read more
rk plug to stuff the piston with rope or rag to seize up the piston, and then removing the front motor casing to access the front muffler screw). Once you access both muffler screws remove them with the t20 torx driver. Install the new muffler with the small gasket inside the housing, and the larger gasket/heat shield between the muffler and the motor.
Read less
Was this instruction helpful to you?
Thank you for voting!