512391 Troy-Bilt Trimmer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Robert from ORANGE, CA
- Parts Used:
- 753-06797
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
One of the two fuel lines cracked and leaking
Removed the 6 screws holding the red plastic cover, tank, and the old fuel lines from the carburetor. Placed the new tank in the sunlight for a few minutes to soften the new fuel lines. Then attached the new lines to the carburetor and replaced the cover
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Henry N from DEERFIELD BCH, FL
- Parts Used:
- 753-06281
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 1- 2 hours
Drive shaft stop spinning
Remove screws from cover insert New parts put everything back together making sure not damage electrical low voltage switch l.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from TICKFAW, LA
- Parts Used:
- 753-06880
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Top drive shaft on my craftsman wc2200 grass trimmer broke
Drive shaft replacement was very easy . Minimal tools were required. Just disconnect the throttle cable, mainly for easier movement of trigger handle. Then remove the guide handle and the trigger mechanism and base. Reassemble reverse order.
Was this instruction helpful to you?
Thank you for voting!