Models
>
ST100
ST100 (Type 2) Black and Decker Trimmer
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for ST100
Viewing 1 of 1
Keep searches simple, eg. "belt" or "pump".
$15.95
This is a genuine part which is supplied directly from the original equipment manufacturer and is used with Craftsman hedge trimmers. The cap holds in the spool and bumper to the spool housing. This p...
On Order
$6.25
Genuine Black and Decker replacement part, it is sold individually. The purpose of the 682235-00 spring is to keep tension between the spool and the spool housing. Overtime the spring will lose its t...
On Order
$6.25
This is a Genuine Manufacturer Sourced replacement part used on a variety of Black and Decker Trimmers/Edgers. This item is Sold Individually. Switches are a commonly replaced part in power tools, han...
In Stock
Order now and your part arrives by Mar 26
$6.25
Genuine Black and Decker replacement part This brush is sold individually, 2 are needed for the tools shown below It is always best to replace both brushes, even if only one is worn. Worn brushes f...
On Order
$6.25
This is a genuine DeWalt replacement part that has been sourced from the original manufacturer to be used with electric trimmers. The copper contact is used to link the switch assembly to the extensio...
In Stock
Order now and your part arrives by Mar 26
This brush holder is an authentic manufacturer sourced replacement part that is used with Dewalt and Black and Decker power tools. This part is designed to secure the carbon brush which is sold separa...
In Stock
Order now and your part arrives by Mar 26
$6.25
It is a high-quality replacement part that is supplied by original equipment manufacturer for use with Black and Decker and Porter Cable power equipment. The purpose of the brush spring is to provide ...
In Stock
Order now and your part arrives by Mar 26
Special Order
In Stock
Order now and your part arrives by Mar 26
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Curtis from Huntsville, AL
- Parts Used:
- 87486-00
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Broken power input terminal
I found this unit by the side of the road. One power input terminal was loose. Inside it was broken. Replacement was to remove the screws, pull out the wire, and cut the wire next to the terminal. I was able to strip the wire and crimp it in the terminal. I then soldered both terminals for a good connection.
Was this instruction helpful to you?
Thank you for voting!