Models
>
UCG1500N0WW
UCG1500N0WW General Electric Trash Compactor
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for UCG1500N0WW
Viewing 12 of 12
Keep searches simple, eg. "belt" or "pump".
On Order
$25.25
This power nut is for trash compactor and attaches to the side of the ram and is threaded. As the power screw rotates, it feeds through the power nut pulling the ram down to compact the trash.
In Stock
Order now and your part arrives by Aug 10
$21.95
This is a top limit directional switch for a trash compactor. The directional switch reverses the motor direction when the trash compactor has reached the top of the drawer. If your trash compactor is...
In Stock
Order now and your part arrives by Aug 10
$17.44
The drawer roller attaches to the bottom of the drawer and allows the drawer to roll in and out.
In Stock
Order now and your part arrives by Aug 10
$43.95
This frame roller assembly allows a trash compactor drawer to glide smoothly in and out, reducing strain and preventing grinding or squeaking noises during operation. When the rollers wear down, the d...
In Stock
Order now and your part arrives by Aug 10
On Order
On Order
In Stock
Order now and your part arrives by Aug 10
In Stock
Order now and your part arrives by Aug 10
Special Order
Special Order
Special Order
Common Problems and Symptoms for UCG1500N0WW
Viewing 4 of 4Drawer is hard to open and or close
Fixed by these parts
How to fix it
Doesn’t stop at end of compacting cycle
Fixed by these parts
How to fix it
Compactor ram gets stuck
Fixed by these parts
How to fix it
Won’t stay on
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Brian from HOUSTON, TX
- Parts Used:
- WC21X20249
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Trash compactor would not shut off at end of cycle. Would have to manually turn it off.
Removed compactor from opening. Using screw driver unthreaded 4 screws from top and then removed the on/off dial. Face plate came off easy and provided access to relay switch bank. Unscrewed two screws which allowed both relay switches to be removed and replaced. Recommend replacing both relay switches. Reassembled and compactor work
... Read more
ed fine. Very easy job. If your compactor is making a machine gun noise during the return cycle then this will solve your problem.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- john from joplin, MO
- Parts Used:
- WC02X20287
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Nutdriver, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
plastic nut was stripped
replaced drive nuts only problems i had was to adjust shutoff switch
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mark from SCOTTSDALE, AZ
- Parts Used:
- WC21X20249
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
Had to hold foot petal in up position for trash compactor ram to complete cycle
Note that the above problem was not due to a bad direction switch. The centrifugal switch (not a replaceable part) inside the motor had failed. Replacing the entire motor is the solution. I downloaded a service manual for this model which decribes how to replace the motor.
Was this instruction helpful to you?
Thank you for voting!