21A-645A7115HPCRT (2007) Troy-Bilt Tiller

This nut is fit for lawn and garden equipment and is used to resist loosening when properly threaded onto a bolt. The nut is sold individually. The diameter of the nut is 5/16 inches and the thread si...

This item has been OEM sourced to ensure quality. The metal bolo tine is intended to be used with tillers from Troy-Bilt. This part attaches to the tine holder on the right-hand side and is used to di...

This item is an authentic Troy-Bilt replacement part that has been sourced from the original manufacturer to be used with tillers. The metal bolo tine connects to the left tine holder and is used as a...

The tine shaft oil seal is used in tillers and is made of metal and rubber. This part is priced as an individual item, but may require two for proper installation. If the seal becomes dried out or cra...

This is a genuine manufacturer-sourced component which is specially made for use with Troy-Bilt tillers. It is an identical replacement for a missing or a faulty bolo tine that was installed on a new ...

Bushings are generally utilized to provide a tight fit between connected components while allowing for movement with minimum friction. If the bushing is damaged or is missing, this will provide an ide...

This is an authentic Troy-Bilt replacement part that is sourced from the original manufacturer for use with tillers. The forward idler pulley goes next to the flat washer. During the installation proc...