Models
>
15009C
15009C (15009C0300101-0400101) Troy-Bilt Tiller
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$17.06
This is a genuine OEM sourced item that is specially produced for Troy-Bilt and MTD roto-tillers. The purpose of this component is to provide a tight seal which will prevent oil from leaking. It is an...
In Stock
Order now and your part arrives by Mar 30
$39.36
This is a genuine manufacturer-sourced component which is specially made for use with Troy-Bilt tillers. It is an identical replacement for a missing or a faulty bolo tine that was installed on a new ...
Special Order
Special Order
Special Order
$14.25
This is a genuine manufacturer-sourced replacement part which is specially designed for use with Troy-Bilt tillers. It provides a tight seal between connected parts, please refer to the appropriate di...
Special Order
$7.27
An authentic item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt tillers. It is a special gasket that helps to provide a tight seal for the front bearing cap...
Special Order
$23.83
Bushings are generally utilized to provide a tight fit between connected components while allowing for movement with minimum friction. If the bushing is damaged or is missing, this will provide an ide...
Special Order
$51.84
This is an authentic Troy-Bilt replacement part that is sourced from the original manufacturer for use with tillers. The forward idler pulley goes next to the flat washer. During the installation proc...
On Order
$6.51
It is a genuine item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt and MTD lawn and garden equipment. This is a special component that is utilized to provid...
Special Order
Special Order
$14.64
This is a genuine OEM sourced hardware that is specially made for MTD and Troy-Bilt tillers. It is utilized to provide a tight seal on the eccentric shaft, unfortunately, over time it will wear out an...
Special Order
$6.64
This is a genuine Troy-Bilt replacement part for use in edgers, aerators, and tillers. The clevis pin attaches to the hair pin cotter. A set of pliers may be needed during the replacement of this part...
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Gary from ELGIN, OK
- Parts Used:
- 756-04170
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Bearing seized
Pull belt cover, 2 nuts
Remove tensioner, 1 nut
Slide old tensioner off and replace
Remove tensioner, 1 nut
Slide old tensioner off and replace
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Norman from RAINIER, WA
- Parts Used:
- 921-04035
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Socket set, Wrench set
1inch shaft and wheels have to be removed first.
Wheels had to be cut off of the axle in order to get to the seals. The center of wheel is 3in wide and axle isn't tappered on troy bilt pony model wheels where rusted on.
Was this instruction helpful to you?
Thank you for voting!