Models
>
21A-332C765
21A-332C765 (2005) Bolens Tiller
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for 21A-332C765
Viewing 2 of 2_WW_1.gif "Page A Diagram and Parts List for 2005 Bolens Tiller")
_WW_2.gif "Page B Diagram and Parts List for 2005 Bolens Tiller")
Keep searches simple, eg. "belt" or "pump".
$26.85
This is a drive belt and it is used on various outdoor lawn equipment. This part is made of rubber and is sold individually. It measures to be 35.80 inches by 0.5 inches. This part drives the transmis...
In Stock
$4.44
This is a TT screw, but it is also called a fastener, and it is used on multiple outdoor tools. This part is a Tri-Round or Tri-Lobular thread forming screw, it is 0.25 inches in diameter, 0.5 inches ...
In Stock
This is a Belleville washer, and it is used with various lawn and garden equipment around your home. This part has an inner diameter of 0.340 inches and an outer diameter of 0.872 inches. The convex s...
In Stock
$4.95
This lock washer is used to resist the loosening of bolted joints. Repair tip: It is difficult to install the lock washer in a tight place or when the bolt/screw is pointing down. This lock works with...
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.
Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Junior
July 7, 2023
Pull rope disconnect
For model number 21A-332C765
Hello Junior, thank you for the question. We are providing you with the instructions that will help to contact the rope with the recoil starter assembly.
1- Remove the screws securing the recoil starter assembly cover.
2- Pull out the starter assembly cover.
3- Now rotate the inner pulley multiple times and then align the hole with the outer casing hole.
4- Now pass the rope from both holes and make a knot at the end of the rope that is on the inside of the cover.
5- Now release the pulley and you see it is feeding in by itself.
6- Put the recoil starter assembly back and tighten the screws.
We hope this helps!
Was this helpful?
Thank you for voting!