RK7241S Rockwell Table Saw

Hello Lyle, thank you for the query. We are providing you with the instructions that will help you to replace the motor in the table saw. Loosen the blade-tilt locking knob and tilt the blade to a 90-degree angle. Tighten the blade-tilt locking knob. Raise the blade to its highest cutting position. Push the red button on the blade guard and lift off the blade guard assembly. Insert a slot screwdriver into the large hole in the table and pry out the table insert. Loosen the blade-tilt locking knob. Tilt the saw blade to a 45-degree angle. Tighten the blade-tilt locking knob. Remove the riving knife, locking knob and washer. Remove the riving knife, mounting plate and the anti-kickback pawl. Loosen the blade-tilt locking knob and tilt the blade to a 90-degree angle. Tighten the blade-tilt locking knob. Use the 2 wrenches supplied with the table saw to remove the blade arbor nut. Remove the outer flange washer and saw blade from the arbor. Flip the table saw upside down onto a protected surface. Release the 4 table locking levers that secure the table saw to the support stand. Remove the table saw support stand. Release the 3 green ground wires from the ground wire bracket. Remove the On/Off switch cover mounting screws. Using a wire cutter, cut the white wire at the base of the wire crimp. Pull the black drive motor wire off the reset switch. Using pliers, pull out the motor wire strain relief. Pull the motor wires out of the On/Off switch box cover. To raise the motor up, rotate the handwheel to the lowest motor position. Remove the 4 motor mounting bolts and brackets. Pull out the motor. We hope this helps!