555M Simplicity Snow Blower - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- James from PLAISTOW, NH
- Parts Used:
- 1718593SM
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers, Socket set
replace worn PLASTIC discharge chute linkage gears
start with chute auger and punch out roll pins and cotter pin, reassemble linkage with METAL universal gears
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dana from HAMMOND, IN
- Parts Used:
- 792006
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers, Socket set
Mistreated Briggs & Stratton 206 CC Engine on MTD Chipper
Removed tank and drained old gas.
Removed and disassembled carb. Needed new gaskets and seals, and had to clean corn syrup glaze (separated ethanol) from bowl and everywhere else with carb cleaner.
Throttle linkage was de-plating/rusty. Steel wool and WD40 got it moving again.
Cleaned spark plug electrode.
Reassembled, poured Sea Foam in the bottom of the tank and gave it a few pulls.
Let Sea Foam sit for a while, then filled the tank with Premium.
Blew white smoke for a minute then ran like new. Shredded for a while, then changed the oil.
Removed and disassembled carb. Needed new gaskets and seals, and had to clean corn syrup glaze (separated ethanol) from bowl and everywhere else with carb cleaner.
Throttle linkage was de-plating/rusty. Steel wool and WD40 got it moving again.
Cleaned spark plug electrode.
Reassembled, poured Sea Foam in the bottom of the tank and gave it a few pulls.
Let Sea Foam sit for a while, then filled the tank with Premium.
Blew white smoke for a minute then ran like new. Shredded for a while, then changed the oil.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Larry from ULYSSES, KS
- Parts Used:
- 7028427YP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Installed new scrapper blade
Unbolt old one with 4 screws and nuts and replaced new blade with new screws . Very easy fix with new blade and screws . Thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Freeland from KENNEBUNKPORT, ME
- Parts Used:
- 1725428SM
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Dishwasher control panel cracked when opening the dishwasher door
First I watched the Parts Select video (Dishwasher Control Panel (Part #00475255 - How to replace) on YouTube just to be sure I could do the replacement. I ordered the part (delivered next day) and replaced the control panel in less than 30 minutes while watching the video. One note, you should be prepared to have a small stool or box to set the electrical components on while swapping the buttons on the control panel. I did not want to leave them hanging by the wires and this is not shown on the video.
Was this instruction helpful to you?
Thank you for voting!