31AE7H8G799 MTD Snow Blower

This carriage bolt fits a variety of tools and is sold individually. The square area under the head of the bolt is created to fit into a square hole in your tool. The hole makes sure to restrain the b...

This nut is fit for lawn and garden equipment and is used to resist loosening when properly threaded onto a bolt. The nut is sold individually. The diameter of the nut is 5/16 inches and the thread si...

This slide or skid shoe fits snow blowers and is attached to the auger housing. The shoe slides around the ground to ensure the snow blower glides and moves easily. It also elevates the auger housing ...

This lock nut is used for lawn and garden equipment, and is sold individually. This nut resists loosening when it is correctly threaded onto a bolt in your tool. The measurements are: the diameter of ...

This replacement shear bolt is supplied directly from the original equipment manufacturer for use with Craftsman snowblowers. The purpose of this hardware is to protect your snowblower. If the auger g...

This is a TT screw, but it is also called a fastener, and it is used on multiple outdoor tools. This part is a Tri-Round or Tri-Lobular thread forming screw, it is 0.25 inches in diameter, 0.5 inches ...

This is a plastic bushing for your lawn equipment. It fits onto the side of your fuel tank, and holds the fuel fittings so they do not touch sharp metal. This part is made of plastic, and will eventua...

This is a flange lock nut, and it is used with various outdoor tools and equipment. The flange lock nut is all one piece. It has a bottom circular flange and a smaller top hex section. This is a torqu...

This authentic manufacturer-supplied part is designed for Craftsman snowblowers. Flange bushings are used to provide support for components while allowing them to rotate with minimum friction. It is m...

This is a Genuine OEM replacement Belt set designed for use with Snowblower. This part is made out of Rubber and it includes one belt. This belt drives your unit. Make sure to clean pulleys before i...