Models
>
DGRSC304
DGRSC304 Dynasty Smoker
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for DGRSC304
Viewing 4 of 4Keep searches simple, eg. "belt" or "pump".
In Stock
Manufacturer's Number: 20000008 Helps restore luster and remove streaks from stainless steel appliances and cookware.
No Longer Available
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Raymond from BLOOMINGTON, MN
- Parts Used:
- 4396923
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Purchased home but stove had no broiler pan.
Purchased 2 piece broiler pan from this site
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Leon from San Francisco, CA
- Parts Used:
- 70001020
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Oven ignition switch failed
This is actually for a Dynasty (Jade) Range (but that's not an option in the selection).
The repair is very easy - after you shut power off to the stove.
1. Remove all the stove control knobs from the front panel.
2. Remove the 2 phillips head screws on either side of the front control panel.
3. Pull the fr ... Read more ont panel out about 3 inches to expose the back of the switch.
4. Use a flat head screwdriver to push the retention clips down and loosen the switch from the panel.
5. Move the 5 wires connected to the switch using pliers, one by one to the new switch.
6. Push the new switch into the panel.
7. Replace the panel and controls.
8. Restore power and test.
The repair is very easy - after you shut power off to the stove.
1. Remove all the stove control knobs from the front panel.
2. Remove the 2 phillips head screws on either side of the front control panel.
3. Pull the fr ... Read more ont panel out about 3 inches to expose the back of the switch.
4. Use a flat head screwdriver to push the retention clips down and loosen the switch from the panel.
5. Move the 5 wires connected to the switch using pliers, one by one to the new switch.
6. Push the new switch into the panel.
7. Replace the panel and controls.
8. Restore power and test.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- RAYMOND from JACKSONVILLE, FL
- Parts Used:
- 4396923
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broiler pan missing
ordered new broiler pan
Was this instruction helpful to you?
Thank you for voting!