R4518 Ridgid Saw

This is a Genuine Manufacturer Sourced replacement part. This is a Carbon Brush with Lead Wire attached and a Spring. This Brush is Sold Individually. Please note Brush Holder is Sold Separately. Car...

This is an authentic OEM sourced item, not an aftermarket imitation. It is specially made for Ridgid and Ryobi table saws. This wrench allows you to secure or remove a saw blade. Angular profile of th...

This item has been sourced from the original manufacturer and is intended to be used with table saws from Ridgid. The metal arbor nut fits over the outer blade washer and is used to secure the saw's b...

This metal washer is an original part from Ridgid for table saws. It helps to attach the handwheel to the handwheel grip with a lock nut. This is a small part so it will need to be replaced if it beco...

This authentic lock nut is supplied by the original equipment manufacturer for use with Ridgid table saws. It is a special component which helps to secure the handwheel. Over time thread may wear out ...

The spring pin attaches to the clutch. This item is available as an individual replacement part. It is an OEM from Ryobi and Ridgid for use in table saws. When replacing this part a hammer and a punch...

This part is an OEM from Ridgid for use in table saws. The brush holder goes between the brush and the motor housing. A screwdriver may be required to replace this item if it becomes broken. This part...

This is an authentic replacement part that has been sourced from the original manufacturer to be used with table saws from Ryobi and Ridgid. The plastic o-ring is used to provide spacing and to suppor...