6141 (SER 763A) Milwaukee Sander Polisher

This carbon brush lead or also known as a carbon motor brush fits the following tools: angle grinders, nibbler and shears, sander polishers, and jig saws. This includes the brush and a wire lead attac...

This is a cord set for your power tools. It is constructed with a tough outer-rubber insulation for a longer life span. The 18-gauge power cord is 8 feet long, and comes with 2 prongs and 2 wires. Thi...

This is a Genuine OEM replacement Flange Nut used on Milwaukee Grinders. This part secures the Grinding Disk to the unit. A Spanner Wrench (Sold Separately) is used to tighten and loosen this part. It...

This Torx screw fits a variety of lawn and gardening tools. The screw has a diameter of 8, 16 thread counts, and 5/8 inches for the length. Refer to diagram provided by the manufacturer for further in...

This is a brush spring for your power tools. It keeps the brush tight against the armature. Over time the carbon brush will wear down, and heat will be created. This could cause your spring to lose te...

This is an authentic and original replacement part. It fits a variety of Milwaukee handheld power tools. This cord protector prevents strain/damage to the cord where it connects to the tool. One (1) r...

This replacement side handle is a genuine Milwaukee part, not an aftermarket imitation. It is sourced directly from original equipment manufacturer for use with sanders and grinders. This side handle ...

This rubber bumper protects surfaces from scratching when moving around in your tool. The rubber bumper also reduces sound or too much friction. Refer to the diagram provided by the manufacturer for t...

This right brush holder is an specially manufactured for Milwaukee power tools. It is a genuine replacement part that is sourced directly from original equipment manufacturer. This part is used to sec...

Inner diameter 3/8" Outer Diameter 1"

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Milwaukee power tools. The purpose of a brush holder is to secure a carbon brush in the housing, pl...

This part is provided by the original manufacturer for Milwaukee power tools. The metal bearing is used to prevent friction between moving parts, and usually goes inside a gear. The item includes one ...