3608B Makita Router

This is a cord guard, also known as a strain reliever, for your power tools. Power tool cords go through a lot of stress during usage, and this part is designed to remove some of that stress from the ...

This cord is a genuine Makita replacement part and is sold individually. This cord is made for the double insulated tools shown below It is a two wire cord with two prongs and does not need a ground wire.

Included in Part Number 516306-1. rnThis Ball Bearing is sealed on both sides. This genuine Makita replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating par...

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it ha...

This genuine Makita replacement screw is a high quality piece of hardware, not an aftermarket imitation. It is sourced directly from original equipment manufacturer for use with a variety of power too...

This is a Trigger switch that has 4 leads and a locking mechanism for the trigger. This authentic Makita replacement part is sold individually. Switches are commonly replaced parts in power tool...

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutter...

This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out ...

This is an OEM approved replacement Collet Nut that fits a various number of Makita router tools. The nut is used to form a collar around the tool, which when tightened works as a clamp. Made of durab...

This is an original replacement part manufactured for use with Makita routers and circular saws. The special spanner wrench is used to tighten and loosen the collet nut or blade nut. This spanner wren...

This replacement hex nut is sourced directly from the original equipment manufacturer for use with Makita power tools. This is standard hardware which has multiple applications based on your model, pl...