Models > RS265LABP

RS265LABP (XAA-0000) Samsung Refrigerator

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for RS265LABP

Viewing 5 of 5
Keep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by Mar 23
In Stock
Order now and your part arrives by Mar 23
This condenser fan blade (part number DA31-00010D) is for refrigerators. Condenser fan blade DA31-00010D moves air across the condenser coil to cool the hot refrigerant before it enters the evaporator...
In Stock
Order now and your part arrives by Mar 23
In Stock
Order now and your part arrives by Mar 23
In Stock
Order now and your part arrives by Mar 23
$17.80
In Stock
Order now and your part arrives by Mar 23
In Stock
Order now and your part arrives by Mar 23
No Longer Available
In Stock
Order now and your part arrives by Mar 23
No Longer Available
In Stock
Order now and your part arrives by Mar 23
In Stock
Order now and your part arrives by Mar 23

Questions and Answers

Be the first to ask our experts a question about this part!

Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Ductri from RESEDA, CA
Parts Used:
DA63-01809A, DA31-00016A
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Screw drivers
Refrigeration side was not cold enough.
Replaced the Broken Cover Motor and the Fan Blade. Fan motor was test with 12VDC power supply, or by replugging fan connector and holding down the door closing switch.

After a few days, the fan made loud noise. Due to defrog heater was open when it was test with ohmmeter. Ice deposited around the fan.

I had to buy a whole ASSY EVAP-REF part # DA96-00395C, and seperated the evaperator, and replaced the heater and sensor.
Spray bottle was used spray hot water to de-iced the evaperator. And salt accelerated the ice melting process.

Note: spray water to clean salt before installing new parts
1 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
RUSSELL from LAS VEGAS, NV
Parts Used:
DA66-00294A
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Lever Dispenser-Ice Was Broken.
Using the putty knife, pry off the faceplate for the ice/water dispenser. Disconnect the wire harness. Using philips head screwdriver, remove the dispenser assembly. Remove the old dispenser and replace. Reverse for reassembly. Note * I should have bought the water dispenser lever and replaced it as well since I had the assembly out. Secondary note * be mindful during reassembly to not put pressure on the water dispenser or have a glass handy. :)
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!