Models > RH25H5611BC > Instructions

RH25H5611BC (AA-0000) Samsung Refrigerator - Instructions

Jump to:

All Instructions for the RH25H5611BC
1 - 4 of 4
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
frank from LARGO, FL
Parts Used:
DA31-00146J
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Refrigerator not cooling properly
Remove shelves then at bottom is a cover that holds fan in place remove a total of 6 screws. 2 of them are behind lamp lens cover you have to remove lamp lens to see them. Then use hair dryer to melt ice to allow cover to come off. Slow remove cover top left side there are two connector you have to disconnect. Then there are 4 screw to pull fan Assy from cover. 1 screw to get to fan motor.on fan cage remove coil spring then pull cage of . Then unplug connector from fan motor. Note to clean drain hole I use a small hose/ funnel and warm water to open hole back up.
11 of 14 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
theodore from PUEBLO, CO
Parts Used:
DA31-00146E
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
freezer was cold fridge was not
Took shelving out of freezer removed panel. Took second panel
out and removed motor. Whole repair took 45 minutes. Works perfect
4 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ira from MANHATTAN BCH, CA
Parts Used:
DA97-13415B
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
ice dispenser screw cracked
replaced ice "bucket"..snapped out old one, snapped in new
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Sara from BAKERS MILLS, NY
Parts Used:
DA61-03734A
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
We misplaced the mounting screws for our handles while moving.
It was easy! I just used an alan wrench to losen the side bolt, then slid the handle into the new mounting screws that I had hand-screwed and then tightened it all up.
3 of 13 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the RH25H5611BC
1 - 4 of 4