Models > RH22H9010SG

RH22H9010SG ((AA)(0003)) Samsung Refrigerator

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
In Stock
In Stock
The Samsung Defrost Sensor (DA32-10105R) is a genuine part designed specifically for Samsung refrigerators. This sensor, sometimes referred to as a defrost thermostat or defrost temperature sensor, is...
In Stock
This part helps refrigerator door open and close properly.
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
$50.48
In Stock

Questions and Answers

Be the first to ask our experts a question about this part!

Common Problems and Symptoms for RH22H9010SG

Viewing 2 of 2
Fridge too warm
Fixed by these parts
Fixing Fixing
How to fix it
Door won’t open or close
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Richard from GULFPORT, MS
Parts Used:
DA32-10104N
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Evaporator frozen (refrigrator section) and allowing top section to lose cooling
This is the Samsung French door refrigerator style that so many people have complained about freezing up and not cooling the top section. I first changed out the defrost thermostat and this did not correct the problem. I done a quick resistance check on the temp sensor that's mounted on the evaporator itself. The resistance would change w hen holding an ice cube on the sensor so I just assumed it was ok. PLEASE TAKE NOTE: When performing a resistance check on this sensor, make sure your readings match the Samsung temp/resistance chart in their literature. My sensor was way off calibration and was causing the freeze up. Its working as designed now and DW is happy again. Learn from my mistake.
47 of 70 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ira from MANHATTAN BCH, CA
Parts Used:
DA97-13415B
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
ice dispenser screw cracked
replaced ice "bucket"..snapped out old one, snapped in new
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
David from WILMINGTON, DE
Parts Used:
DA32-10105R
Difficulty Level:
Really Easy
Total Repair Time:
More than 2 hours
Tools:
Pliers, Screw drivers
Ice Build up behind refrigerator internal panel
I performed the repair to my own refrigerator, after watching multiple YouTube videos. I installed a secondary heater for the defrost coils and replaced the defrost sensor. The defrost sensor was actually bad. Today, 1/27/2024 I rechecked the fix from last week. All seems to be good so far.

If I get any build up of any ice on t he bottom tray of the recessed panel where the drain port is located. I suspect I will also need a new Defrost Heater as well. For now the refrigerator is operating as expected. There is a small amount of ice build up as of today.

Also, I had recently replaced the drain tubes, added a longer heater element part to fit the drain hole, and cleaned the fins in the back of the refrigerator. Thank you.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!