If the light inside your fridge is not coming on, or if it is staying on continuously, there may be an issue with your door switch. When the door to your fridge is closed, the button on the switch is...
This front plate assembly, often called a mullion or flipper, fits select LG and Kenmore French-door refrigerators. It helps seal the gap between the doors to prevent air leaks and maintain proper tem...
This refrigerator water filter replacement is for 2010 LG refrigerators that have either forward French doors or are the four-door dispensing models. This filter is designed to minimize impurities tha...
Refrigerator Air Filters are a key component for neutralizing odors and ensuring a fresh stream of air into your refrigerator. Swapping your old filter out for a fresh one isn’t difficult and should t...
This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refri...
This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh ...
If the glass shelf above your fridge’s crisper drawers is cracked or missing this replacement is a quick fix. Made from strong tempered glass it gives you a sturdy spot to store food and lets you see ...
Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Scott
26 days ago
Plug in refrigerator it starts runs for about 5to10 minutes then it shuts off and blinks 6 times.
For model number LFXS24623W
Hi Scott, thank you for the question. It usually signals a compressor overload, high amperage draw, or current trip protecting the system from failing. Unplug the refrigerator completely from the wall outlet. Leave it unplugged for a full 10 to 15 minutes to allow the control board to drain its residual power and reset its error memory. Plug it back directly into the wall. If the issue persists, you may need to replace the compressor overload protector, part number 6750CL0001D. A bad overload protector fails to manage electrical current properly during a cycle. We hope this solves your problem!
1. Shut off water to refrigerator. 2. Removed bottom sheet metal cover (6 screws). 3. Removed leaking water inlet valve assembly from refrigerator (1 screw). 4. Remove water inlet tube (loosen nut) and tube back to refrigerator (pull from water valve after remove cotter pin washer). 5. Detach two electrical wire harnesses. 6. Install new
... Read morewater inlet valve assembly to refrigerator (1 screw). 7. Replace both water tubes to water inlet assembly. 8. Re-attach both wiring harnesses. 9. Turn water to refrigerator on. 10. Check for leaks. 11. Re-attach bottom sheet cover (6 screws).
Video makes it look easy. Kenmore refrigerator does not have "groove" along the right hand side of switch that allows for pushing down on release. Used a thin screwdriver to get under to push while holding switch edge with pliers. Kept slipping. Tape sides to avoid scratching inside of refrigerator.
