Models > 5648946080

5648946080 Kenmore Refrigerator

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for 5648946080

Viewing 4 of 4
Accessories Diagram and Parts List for Kenmore Refrigerator
Accessories
Cabinet Diagram and Parts List for Kenmore Refrigerator
Cabinet
Cooling Unit Diagram and Parts List for Kenmore Refrigerator
Cooling Unit
Door Diagram and Parts List for Kenmore Refrigerator
Door
Keep searches simple, eg. "belt" or "pump".
Tub Sound Shield - Insulation – Part Number: W11086533
$27.76
In Stock
Order now and your part arrives by Mar 19
Dishwasher Upper Spray Arm – Part Number: WP304204
$107.95
This spray arm is just underneath your upper rack.
Special Order
Lint Filter – Part Number: 300838
This filter collects lint as it passes through the dryer vent.
No Longer Available
Water Inlet Valve – Part Number: WP303650
This water inlet valve is intended for use with under counter style dishwashers. It has a 3/8 of an inch FPT (female pipe thread) valve and a mounting bracket. - This water inlet valve should be loca...
No Longer Available
THERMOSTAT – Part Number: 303282
No Longer Available
THERMOSTAT – Part Number: 305864
No Longer Available
Refrigerator owner
No Longer Available
NLABRACKET, OVEN ORIFICE – Part Number: 300091
No Longer Available
MANIFOLD ASSEMBLY. NLA – Part Number: 300100
No Longer Available
NLASUB 300113B – Part Number: 300113
No Longer Available
Use/care – Part Number: 300876
No Longer Available
Refrigerator grommet – Part Number: 300878
No Longer Available
View More

Questions and Answers

Be the first to ask our experts a question about this part!

Common Problems and Symptoms for 5648946080

Viewing 1 of 1
Noisy
Fixed by these parts
Fixing
How to fix it
Replacing the Lint Filter

Replacing the Lint Filter

View More
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Mickey from Novato, CA
Parts Used:
WP304204
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
One of the 4 latches that holds the spray arm to the top rack broke and fell off.
It just snaps back in but it was a very tight fit and took two people to force it in. Plus I had no instructions and hadn't seen it before it broke so it took a little time to figure out where it was supposed to go. The arm doesn't connected to anything except the rack. I guess water just shoots up into it from below.
19 of 26 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
John from Sante Fe, NM
Parts Used:
300838
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Dryer of elderly relative was very hot and dried clothes slowly.
The lint filter was torn in a couple of places. This let lint go into the dryer vent pipe over a period of years. I ordered a new lint filter and replaced it. I also pulled out the plastic piece the filter sits against and cleaned out behind it. The vent went to the roof. I pulled off the rain shield and found that the vent pipe was almost completely packed with lint. I pulled out all I could reach and nailed a 2x2 inch and 1x2 inch together and used it to scrape out the vent pipe. I placed a flashlight in the bottom and checked to see it was clean. I replaced the rain shield and carefully reconnected the dryer to the vent. Now the dryer runs cool as it should.
Read less
16 of 27 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Julia from Colorado Springs, CO
Parts Used:
WP304204
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Upper Spray Arm broken off
It was so easy , I first put one side of the clamp on the little rack area in the center of the upper rack then pushed the other side on. It took less than five minutes. No tools needed. Julia
7 of 10 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
View More