Models > 25369234702

25369234702 Kenmore Refrigerator

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Manuals & Guides for 25369234702

Click to download
Keep searches simple, eg. "belt" or "pump".
For select refrigerators, the white right-hand track supports the meat pan. Check the refrigerator model number to confirm fit before ordering. This is an OEM replacement part.
In Stock
Order now and your part arrives by Nov 28
To help keep cold air inside and warm air carrying moisture out, this white refrigerator door gasket seals the fresh food section. Its flexible vinyl edge fits around the inner door panel and makes co...
In Stock
Order now and your part arrives by Nov 28
This 120 volt, 60 hertz defrost timer is used to switch the refrigerator into a 30 minute defrost cycle after eight hours of compressor run time. The cycle allows the heater to clear frost from the ev...
In Stock
Order now and your part arrives by Nov 28
This left side rail is used to support and guide the refrigerator meat drawer as it slides open and closed. With a cracked or broken rail, the drawer may sag, catch, or move unevenly. Sourced directly...
In Stock
Order now and your part arrives by Nov 28
$21.95
This 40-watt light bulb has a standard screw-in base and is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM...
In Stock
Order now and your part arrives by Nov 28
A crisper pan cover goes over the crisper pan area in your refrigerator. This OEM part replaces the cover for that area.
No Longer Available
During a refrigerator defrost cycle, this thermostat helps protect the evaporator from overheating. Cooling problems or a failure to defrost can point to an issue in the defrost system, but do not con...
In Stock
Order now and your part arrives by Nov 28
The run capacitor helps the compressor start and supports its operation in a refrigerator or freezer. This OEM replacement has a capacitance of 15 MFD. Check fit against your appliance model before or...
In Stock
Order now and your part arrives by Nov 28
Cold air moves through the food compartments with help from this refrigerator evaporator fan motor kit. The motor drives the fan that circulates air across the evaporator coils and distributes cooled ...
In Stock
Order now and your part arrives by Nov 28
Cover the produce compartments and restore the storage surface above them with this refrigerator crisper cover glass insert. The pane sits in the shelf frame over the crisper drawers. A cracked, chipp...
In Stock
Order now and your part arrives by Nov 28
$26.35
For fastening a refrigerator or freezer door handle, this OEM screw has a #10-16 thread and is 1/2 inch long. It has a Phillips/Square drive. Confirm it matches your appliance before ordering.
In Stock
Order now and your part arrives by Nov 28
$109.64
Meats, snacks, and other refrigerated foods stay organized in this clear plastic pantry drawer. The sliding pan provides contained storage in the fresh food section, while transparent sides make the c...
In Stock
Order now and your part arrives by Nov 28

Common Problems and Symptoms for 25369234702

Viewing 17 of 17
Fridge too warm
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Freezer section too warm
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Door won’t open or close
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Freezer not defrosting
Fixed by these parts
Fixing Fixing
How to fix it
Light not working
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Noisy
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Fridge and Freezer are too warm
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Will Not Start
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Leaking
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Door Sweating
Fixed by these parts
Fixing Fixing
How to fix it
Too warm
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Fridge runs too long
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Won’t start
Fixed by these parts
Fixing
How to fix it
Fridge too cold
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Frost buildup
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Freezer too cold
Fixed by these parts
Fixing Fixing
How to fix it
Clicking sound
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Matthew from Washington, DC
Parts Used:
242193213
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Refrigerator door gasket torn
No instructions included, so it took a little bit of staring at the new part to figure out how it works. The barbed ridge on the gasket fits into a slot on the door. The flat face of the gasket has an internal magnetic strip that helps keep the seal tight against the steel face of the refrigerator. Installation requires no tools. This is the basic process:
1) Unbox the new gasket and get it ready to install so you don't have to leave the fridge open too long.
2) Open the door and grab the old gasket at one of the corners and pull away. This will unseat the barbed ridge I mentioned above. Work your way around the door until the whole gasket is free.
3) Set aside the old gasket
4) Grab a moistened paper towel and wipe down the (now exposed) sealing surface of the fridge and door.
5) Align the new gasket in the door and start pushing the barb into place. I found that the new gasket seemed slightly oversize compared to the original, so it took a little tweaking. What worked for me was to get all the corners seated, then work my way around the door making sure the gasket is fully seated.
6) Once you have the new gasket installed, close the door to make sure everything fits OK.
7) Open the door again and run your finger along the inside edge of the gasket seal. What you want to do is fold the edge of the gasket down so it lays flat against the outer wall of the door.
8) Shut the door and look from the sides and top to try to spot any gaps. You should be able to poke the gasket from the side and get the magnet strips to click into place. It seems like after a day or so the gasket 'relaxed' and I didn't have to worry about this anymore.
9) Dispose of the old gasket. I was able to pull the gasket into four pieces (separating at the corners) so it would fit in my city trash can...
317 of 336 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Greg from Hanover Township, PA
Parts Used:
5303918202
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers
evaporator coil kept freezing up, refridgerator warm.
This was the second part I tried. The defrost timer was first, but that did not fix it. To do this I had to remove the ice maker and the back plate of the freezer. Then I defrosted the coil and cut the wires. stripped them back and installed the new thermostat. re-assembled and tested. has been working great ever since.
186 of 209 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Bruce from Alton, IL
Parts Used:
241537103
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
Refrigerator would not run but interior light was on.
I unplugged the refrigerator, then opened the door and removed four screws holding the plastic electrical panel to the interior top of the main refrigerator compartment and noticed the cold control was corroded badly, apparently from moisture in the panel. I ordered a new one from partselect.com. When it arrived the next day, I then pul led off the control knob, unclipped the cold control, unplugged the three wires to the control, then removed the styrofoam insulation blocks holding the thermocouple wire and then removed the thermocouple wire to complete the removal. I then reversed the process to install the new thermostat and control. That is repositioned the thermocouple wire, put the insulation blocks back to hold the wire, then replugged the three electrical wires, clipped the control back and pushed the control knob back on and finally screwed the panel back to the top of the main compartment and plugged the refrigerator electrical cord back in to provide current to the refrigerator. It immediately started up and ran fine. Total time - about 8 minutes.
184 of 248 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!