36366122010 Kenmore Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Robert from Williamstown, NY
- Parts Used:
- WR50X133
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
defrost drain tube freezing up and stopping circulating fan motor
shut down power- removed plastic covering in refrigerator -installed new part- This has been installed for about 1 week and as of today every thing is working fine. This problem would occur about every 1-2months. So I will not really know for sure until some time goes by
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Eric from NEW YORK, NY
- Parts Used:
- WR02X10520
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Screw drivers
Noisy refrigerator
I visually inspected the compressor and narrowed down the source of the noise to the freezer area. Then I removed the doors and the screws securing the divider panel. Next I removed the bottom panel of the freezer, the styrofoam insullation panel and the evaporator motor. The motor is mounted between two grommets. I replaced the grommet facing the fan blades. The aluminum reflector below the styrofoam insulation panel had also come loose. I reattached it and reassembled the refrigerator in reverse order. The noise is gone!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tyndol from BLOOMFIELD, NJ
- Parts Used:
- WR2X5795
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Retainer bar fell off on the bottom of the door.
Pliers only needed if the bar ends needs to be straightened. Attach clips to bar and clip on to the door.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lawrence from Seaboard, NC
- Parts Used:
- WR50X133
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
defrost heater would not come on
Removed old defrost heater, cut wire then put heat shrink tubeing on wire,spliced wires slid tubing over splice applyed heat. JOB NONE
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary R from Granby, CO
- Parts Used:
- WR51X419
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Defroster element was shattered in pieces
Turned refrigerator off, removed freezer door, removed plastic bottom of freezer. Used hair dryer to defrost freezer elements. Unplugged broken freezer element and plugged in new element. Saved $65.00 by doing it myself.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mark from Moraga, CA
- Parts Used:
- WR50X133
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Refrigerator (top warm) but Freezer Fine
-- Hardest part was removing the section to get into the Defrost Thermostat. Used a hand scraper to push plastic piece back wards (39 in parts diagram) once pushed back about 1/4" it then pops up and can come out (towards the front). Noticed that the evaporator was full of ice and the fan was working). Replaced Thermostat after defrosting evaporator... works like a charm.
Was this instruction helpful to you?
Thank you for voting!