Models > JS42NXFXDE01 > Instructions

JS42NXFXDE01 Jenn-Air Refrigerator - Instructions

Jump to:

All Instructions for the JS42NXFXDE01
1 - 15 of 43
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Kate from Jacksonville, FL
Parts Used:
EDR3RXD1
Difficulty Level:
Very Difficult
Total Repair Time:
30 - 60 mins
there were directions
We didn't know where the product went and it was very difficult to install.
753 of 1268 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Leroy from Perkiomenville, PA
Parts Used:
EDR3RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
six months the light turns red. time to replace filter
First I shut the water off to the refrigerator.then i pushed the big button in the middle of the grille below the refrigerator door. pulled out the old filter, took the front cap off the old filter put it on the new filter. took the two red caps off the new filter. pushed the filter in till it locked in place. all done! Turned the back on.
306 of 384 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Victoria from Beaverton, OR
Parts Used:
EDR3RXD1
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Water filter replacement
It's simple enough in theory: read the side of the box and follow the instructions. BUT you need to really push the knob in pretty hard (I am a girl, and my hand strength isn't that good). If you don't, when you turn the knob, the filter won't come out, then it's tougher. So: make sure the knob pops before you turn!
141 of 183 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kenneth from SAn Francisco, CA
Parts Used:
EDR3RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
change the water filter light was on.
It was ridiculously easy. Push the button on the filter canister holder at the base of the refrigerator and the spring-loaded mechanism came out smoothly. I unplugged the old filter, took the cap off the new on and plugged it in. After reinserting the filter canister holder and locking it in place, I heard the whoosh of water once again moving through the filter. Very satisfying and very easy to do.
101 of 125 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Baerbel from Jacksonville, FL
Parts Used:
EDR3RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Change Out Filter
It turn one turn on the filter holder, pull out and put new filter in done
63 of 96 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Thomas from Va. Beach, VA
Parts Used:
W11342242
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
shut off arm broke
open ice maker door, use mirror to view slot in front of ice maker, slip piece in place and done
52 of 76 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Leslie from Nipomo, CA
Parts Used:
EDR3RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Water Filter needed to be replaced
It was SOOO easy, I turned and popped out the old filter and turned and snapped in the new one....I don't even think it took a whole minute to replace!!
32 of 44 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Roy from The Villages, FL
Parts Used:
EDR3RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Refrigerator indicated that water filter needed replacement
It took less than 5 minutes to remove the old filter and install the new one. Push a button and the old one pops out, stick in the new one, and you're done.
29 of 41 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Debbie from Tyler, TX
Parts Used:
EDR3RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
water filter needed replacing
followed the instructions on the box
21 of 34 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Denise from Hoschton, GA
Parts Used:
EDR3RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
It was just time to replace the water filter.
We took out the old filter and put in the new one. Ran out a few gallons of water then it was ready to use.
15 of 25 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Roy from Ann Arbor, MI
Parts Used:
WP2266802
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers
Switch went bad
Our unit is a built-in unit so first had to remove the decorative cover panel to expose the internal on/off switch. Turned off the circuit breaker. Disconnected the wires (simple pull-off/push-on). Removed the old switch which meant clipping the plastic tabs holding the switch in position. Inserted the new switch by simply pushing it through the opening being sure to have it in the same alignment ('off' to the back of the unit.) Reconnected the wires making sure to have a white ground wires on the left and the black 'hot' wires on the right. Turned the circuit breaker back on. Turned the switch on. Now it runs.
12 of 18 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Sandra S from Topeka, KS
Parts Used:
EDR3RXD1
Difficulty Level:
Difficult
Total Repair Time:
15 - 30 mins
The wrong filter was sent the first time.
I removed the cap from the filter pushed a lever and removed fliter. I replaced the old filter, removed the caps on the new one and slid it into channel after replacing the outer cap. I removed water from the spigot for 4 mins. and it was ready to go. I pushed the reset button to get the green light to come on.
8 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
David from port st lucie, FL
Parts Used:
EDR3RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Water filter
Just put the new one in.
10 of 18 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Gregory from Milford, OH
Parts Used:
W11342242
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver
Ice maker was over producing
Technician at ASK suggested replacing ice maker. Ordered new ice maker(prompt delevery)then noticed it came without wire arm and white platic "flag". Ordered arm and "flag", replaced all old with new and seems to be doing well. Perhaps all I needed was the plastic "flag" on the limit arm wire. Will never know. The new icemaker wiring had short wires and a connector. Old ice maker had no connector so the short wires were removed and the old wires plugged into the ice maker. Mirror was required in order to see the side wall mounting screws. Very narrow work area, tiny freezer side.
6 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
William from Danville, VA
Parts Used:
EDR3RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
No water to ice maker
Built-in filter was corroded due to age. New filter corrected problem.
7 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the JS42NXFXDE01
1 - 15 of 43