Models > CTX21LAXARWH

CTX21LAXARWH Hotpoint Refrigerator

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
The light switch in your refrigerator is used to turn the light on and off when the fridge door opens or closes. This is considered a closed switch, which means that when the fridge door depresses the...
In Stock
Order now and your part arrives by Nov 23
To support steady compressor operation, this refrigerator run capacitor provides the electrical phase shift needed for the compressor motor to run properly as the cooling system operates. Humming, dif...
In Stock
Order now and your part arrives by Nov 23
$15.26
Sold Individually.
In Stock
Order now and your part arrives by Nov 23
This white fresh food door gasket used to seal the refrigerator door when closed.
In Stock
Order now and your part arrives by Nov 23
In Stock
Order now and your part arrives by Nov 23
This refrigerator reversible door plug covers an unused mounting hole. It snaps into the opening left when door hardware moves to the opposite side, giving the door a neat, finished appearance. The pl...
In Stock
Order now and your part arrives by Nov 23
This part comes with 3 round pin connection terminals. This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra...
In Stock
Order now and your part arrives by Nov 23
This evaporator fan motor operates in a counter clockwise fashion. This motor's shaft is 3/8 of an inch and the motor has two right side terminals. NOTE: Harness wires NO longer come with the part.
No Longer Available
In Stock
Order now and your part arrives by Nov 23
This thermostat comes with the installation wires. L55-30
In Stock
Order now and your part arrives by Nov 23
Sold individually.
No Longer Available

Common Problems and Symptoms for CTX21LAXARWH

Viewing 12 of 12
Light not working
Fixed by these parts
Fixing
How to fix it
Fridge too warm
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Will Not Start
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Noisy
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Freezer section too warm
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Door Sweating
Fixed by these parts
Fixing Fixing
How to fix it
Leaking
Fixed by these parts
Fixing Fixing
How to fix it
Fridge and Freezer are too warm
Fixed by these parts
Fixing
How to fix it
Clicking sound
Fixed by these parts
Fixing
How to fix it
Fridge runs too long
Fixed by these parts
Fixing Fixing
How to fix it
Freezer not defrosting
Fixed by these parts
Fixing
How to fix it
Too warm
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Jonathan from Lilburn, GA
Parts Used:
WR23X37285
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
Sticking Light Switch
I applied some tips learned by reading other reviews. So before I started I grabbed my trusty vise grip pliers and a small screw driver. I locked onto the switch actuator, the part that the refrigerator door pushes in, with the vise grips and pulled on it just hard enough to get the screw driver inserted in the right side to push in the c atch clip so the switch could be pulled out further each time the catch clip was depressed to the next detent. Then I used the screw driver on the left site to encourage the switch past the detents on the left and very quickly the switch was out of the mount. The wires from the refrigerator pulled out with the old switch. I unplugged the old switch from the wires and plugged in the new switch and shoved the new switch back into the mount, wiggled it a couple of times to make sure it was secure and the job was done. Once I applied the vise gripes at first, the whole job took less than a minute.
122 of 178 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
John H from Austin, TX
Parts Used:
WR07X10055
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Relay
Removed back panel. Opened cover to relay attached to the compressor and pulled off replacing with new relay. No problem.

Better than paying $250 for someone else to do it.
42 of 54 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Keith from Fort Worth, TX
Parts Used:
WR60X30349, WR60X114
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
Noisey fan/motor (bad motor bearing ?)
Removed 2 phillips head screws to remove ice maker (could have just loosened them)
Pulled fan off of shaft
Removed 2 phillips head screws on motor bracket , disconnected three motor wires & removed motor.
reversed process to install new motor & fan blade.
Space was a little tight for two hand and arms, but do-able.
37 of 46 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!