Models > CTG18GADARWW

CTG18GADARWW Hotpoint Refrigerator

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for CTG18GADARWW

Viewing 6 of 6
Keep searches simple, eg. "belt" or "pump".
This grommet is found on both the front and back of the fan motor assembly for the condenser and the evaporator in your fridge. It is used to provide a buffer between the fan motor and the mounting br...
In Stock
Order now and your part arrives by Nov 28
This part is a replacement door shelf retainer bar for your refrigerator. The shelf retainer bar connects to the end cap on either side, and the end caps connect it to the refrigerator door. The retai...
In Stock
Order now and your part arrives by Nov 28
To reduce friction at the door pivot, this refrigerator nylon hinge washer fits over the hinge pin to provide a smooth contact surface and maintain proper spacing between hinge components. Possible si...
In Stock
Order now and your part arrives by Nov 28
$28.91
In Stock
Order now and your part arrives by Nov 28
This refrigerator reversible door plug covers an unused mounting hole. It snaps into the opening left when door hardware moves to the opposite side, giving the door a neat, finished appearance. The pl...
In Stock
Order now and your part arrives by Nov 28
This thermostat comes with the installation wires. L55-30
In Stock
Order now and your part arrives by Nov 28
Sold individually.
No Longer Available
No Longer Available
Special Order
Special Order
No Longer Available

Common Problems and Symptoms for CTG18GADARWW

Viewing 6 of 6
Noisy
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Fridge too warm
Fixed by these parts
Fixing Fixing
How to fix it
Door won’t open or close
Fixed by these parts
Fixing
How to fix it
Freezer section too warm
Fixed by these parts
Fixing
How to fix it
Freezer not defrosting
Fixed by these parts
Fixing
How to fix it
Clicking sound
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
David from Greenfield, IN
Parts Used:
WR50X10010
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
freezer coil frozen solid
Removed the back cover of freezer to acess the coil. Turned the timer to defrost and checked the voltage across the heater. Didn't have any. Stayed on the common side of heater and measured on both sides of thermostat and one side didn't have any voltage. Shorted the thermostat wires together and heater started working.
28 of 45 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
John from PARKVILLE, MO
Parts Used:
WR02X10098
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Socket set
Had a 'ticking' sound
Separately (from a different site) purchased new compressor fan and motor. I purchased the grommets here because the other site listed the grommets as temporarily out of stock. I did watch one of the videos on PartSelect about the grommet replacement. Repair was pretty simple, biggest challenge was getting to the screw on the far side o f the motor. Removed the two screws holding the fan motor into place. Removed motor and blade. Reinstalled with new fan blade, new grommet and new motor.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ron from BAKERSFIELD, CA
Parts Used:
WR60X10030
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Old fan had broken blade, needed to be replaced
Unplugged the refrigerator then used the cordless drill to remove the 6 screws on the access panel on the back of the fridge to be able to get to the fan. Was able to pull the fan off by hand and push the new fan on by hand. Plugged the refrigerator by in and watched the fan run for a few minutes then replaced the access panel. Really qui ck and easy repair.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!