GRSS2352AF8 Frigidaire Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Cindy from AMARILLO, TX
- Parts Used:
- 240597220
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
My fridge temp was warm. Freezer temp was ok, but fluctuated some.
I checked the dampener, it worked. The compressor and fan worked. I knew because my freezer was still hovering around 10 degrees. Coils were clean. Thermistor was the only thing it could be. Took all my shelves out. Removed four screws. Took the back panel off. The thermistor sits tucked in on the side. I piped it out, in clipped it. Used my multimeter to test the numbers. Numbers were off just a bit. Ordered the part. Crossed my fingers.,took less then 5 minutes to put the part in. Plugged in the fridge. It was sitting at 33 degrees in about an hour and a half. I can’t believe I fixed it. I knew NOTHING about refrigerators. For how big my fridge is, it would have cost 3,000 and up to get a new one with the same cu ft size. Instead, it cost me $44. That includes shipping. Thank you Parts Select!! Made it so easy to pick the correct part for my model fridge!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- suzanne from vermilion, OH
- Parts Used:
- 241786015
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Gasket/seal was worn/broken on bottom edge.
Pulled the old gasket off and put new gasket/seal on by pressing firmly into slot.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marlene from SCOTTSDALE, AZ
- Parts Used:
- FPPWFU01
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
I had a light come on and tell me I needed a new water filter
Pushed the old filter in and it came out then I pushed in the new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tim from SYLVANIA, OH
- Parts Used:
- 240597220
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
2 drawer undercounter beverage ref not getting cold enough. Wont get below 48°
Took drawers out by removing 2 screws on top of rail near front, then popped black plastic cover off in lower right inside cabinet...sensor just un plugged and new one plugged in easily...did not fix problem though...display set at 34 but bottom drawer reads about 40 at best and upper drawer reads around 55...dont think the 3 little fans inside on back wall have been running
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Debbie from Mount Juliet, TN
- Parts Used:
- 5303918899
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Freezer Cold, but Refrigerator not Cold
We replaced the damper, but it didn't fix the problem. We then purchased and replaced the thermistor. (We had previously replaced the defrost thermostat). The refrigerator side is now cooling better, but not enough. The damper doesn't seem to be opening. So we have now unplugged the damper and left the opening between the refrigerator propped open and the refrigerator side is now cool enough. (We had previously tried keeping the damper open before we replaced the thermistor and the refrigerator didn't cool off. So the thermistor did fix something, but the damper doesn't seem to have been the problem).
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from ROCKINGHAM, VA
- Parts Used:
- FPPWFU01
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Replace Water filter Frigidaire Refrigerator
Followed the simple instructions on the device and in the appliance use and care manual
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Glenn from ETOWAH, NC
- Parts Used:
- 5304527031
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
the control panel was working incorrectly could not change any functions i ordered a new one it came and is the correct one
there is no visible way to remove the old one i have spent hours on line and on the phone with tech support with no results . and have a complete parts diagram.this unit is less than one and a half years old manufactured 9/21 i will never buy frigidaire again
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Stefan from LAKE WORTH, FL
- Parts Used:
- 241786015
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
No problems
Removed old gasket and installed new one by pushing the gasket in the door groove.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nancy from LEHIGH ACRES, FL
- Parts Used:
- 218755504
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Wrench (Adjustable)
No problems
I had no problems. Screws arrived sooner than expected. It was a very simple installation. Very pleased with both the product and service.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ERIC from SAN ANTONIO, TX
- Parts Used:
- 241786015
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Door gasket was split.
Very easy installation just pealed of the old door gasket and snapped in the new one the new gasket fitted perfect.No tools needed.
Was this instruction helpful to you?
Thank you for voting!