Models > FRSS26L3AFA

FRSS26L3AFA Frigidaire Refrigerator

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for FRSS26L3AFA

Viewing 9 of 9
Keep searches simple, eg. "belt" or "pump".
$26.35
For fastening a refrigerator or freezer door handle, this OEM screw has a #10-16 thread and is 1/2 inch long. It has a Phillips/Square drive. Confirm it matches your appliance before ordering.
In Stock
Order now and your part arrives by Nov 23
For your refrigerators water and ice system, this OEM filter uses a push-to-lock connection. Check your refrigerators model number before ordering to confirm compatibility. The filter is rated for 125...
In Stock
Order now and your part arrives by Nov 23
$25.25
This metal shoulder screw is used to secure a refrigerator or freezer door handle to the outer door panel. It is a number 10 AB handle mounting screw and is supplied as one piece. A missing screw, dam...
In Stock
Order now and your part arrives by Nov 23
If your freezer door isn’t sealing tightly or you’re seeing frost build-up, it might be time to replace the door gasket. This magnetic seal helps keep cold air inside and warm air out, making sure you...
In Stock
Order now and your part arrives by Nov 23
This temperature sensor, also known as a thermistor, is responsible for preventing the evaporator within your refrigerator from overheating during its defrosting cycle. This sensor is compatible with ...
In Stock
Order now and your part arrives by Nov 23
Need more room for your milk or juice jugs? This gallon-size door bin snaps into place on your fridge door and gives you back that valuable storage space. It’s a great fix if your original bin is crac...
In Stock
Order now and your part arrives by Nov 23
$50.42
For a top-mount refrigerator or upright freezer, this warm-white LED bulb has an E17 base and is rated for 120 volts. Check your appliance model to confirm fit. It is an OEM replacement.
In Stock
Order now and your part arrives by Nov 23
In Stock
Order now and your part arrives by Nov 23
$35.15
This refrigerator lower defrost drain tube guides melted frost into the drain pan. It carries water away from the cooling compartment after automatic defrost cycles, allowing it to collect near the co...
In Stock
Order now and your part arrives by Nov 23
Cracked glass or bent support brackets can mean your refrigerator needs a replacement shelf. This white OEM glass shelf assembly includes the glass shelf and trim. Check compatibility with your refrig...
In Stock
Order now and your part arrives by Nov 23
$21.95
In Stock
Order now and your part arrives by Nov 23
$19.75
Keep your refrigerator crisper cover in place with this OEM support. If the cover wobbles or sits out of position, its support may need replacement.
In Stock
Order now and your part arrives by Nov 23

Questions and Answers

Be the first to ask our experts a question about this part!

Common Problems and Symptoms for FRSS26L3AFA

Viewing 11 of 11
Fridge too warm
Fixed by these parts
Fixing Fixing
How to fix it
Leaking
Fixed by these parts
How to fix it
Frost buildup
Fixed by these parts
How to fix it
Fridge too cold
Fixed by these parts
Fixing
How to fix it
Door Sweating
Fixed by these parts
How to fix it
Ice maker not making ice
Fixed by these parts
Fixing
How to fix it
Door won’t open or close
Fixed by these parts
How to fix it
Freezer section too warm
Fixed by these parts
How to fix it
Freezer not defrosting
Fixed by these parts
How to fix it
Fridge and Freezer are too warm
Fixed by these parts
How to fix it
Not dispensing water
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Cindy from AMARILLO, TX
Parts Used:
240597220
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
My fridge temp was warm. Freezer temp was ok, but fluctuated some.
I checked the dampener, it worked. The compressor and fan worked. I knew because my freezer was still hovering around 10 degrees. Coils were clean. Thermistor was the only thing it could be. Took all my shelves out. Removed four screws. Took the back panel off. The thermistor sits tucked in on the side. I piped it out, in clipped it. Used my multimeter to test the numbers. Numbers were off just a bit. Ordered the part. Crossed my fingers.,took less then 5 minutes to put the part in. Plugged in the fridge. It was sitting at 33 degrees in about an hour and a half. I can’t believe I fixed it. I knew NOTHING about refrigerators. For how big my fridge is, it would have cost 3,000 and up to get a new one with the same cu ft size. Instead, it cost me $44. That includes shipping. Thank you Parts Select!! Made it so easy to pick the correct part for my model fridge!
58 of 92 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Marlene from SCOTTSDALE, AZ
Parts Used:
FPPWFU01
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
I had a light come on and tell me I needed a new water filter
Pushed the old filter in and it came out then I pushed in the new one.
18 of 27 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Debbie from Mount Juliet, TN
Parts Used:
5303918899
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Freezer Cold, but Refrigerator not Cold
We replaced the damper, but it didn't fix the problem. We then purchased and replaced the thermistor. (We had previously replaced the defrost thermostat). The refrigerator side is now cooling better, but not enough. The damper doesn't seem to be opening. So we have now unplugged the damper and left the opening between the refrigerato r propped open and the refrigerator side is now cool enough. (We had previously tried keeping the damper open before we replaced the thermistor and the refrigerator didn't cool off. So the thermistor did fix something, but the damper doesn't seem to have been the problem).
10 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!