FRSS2623AD9 Frigidaire Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Cindy from AMARILLO, TX
- Parts Used:
- 240597220
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
My fridge temp was warm. Freezer temp was ok, but fluctuated some.
I checked the dampener, it worked. The compressor and fan worked. I knew because my freezer was still hovering around 10 degrees. Coils were clean. Thermistor was the only thing it could be. Took all my shelves out. Removed four screws. Took the back panel off. The thermistor sits tucked in on the side. I piped it out, in clipped it. Used my multimeter to test the numbers. Numbers were off just a bit. Ordered the part. Crossed my fingers.,took less then 5 minutes to put the part in. Plugged in the fridge. It was sitting at 33 degrees in about an hour and a half. I can’t believe I fixed it. I knew NOTHING about refrigerators. For how big my fridge is, it would have cost 3,000 and up to get a new one with the same cu ft size. Instead, it cost me $44. That includes shipping. Thank you Parts Select!! Made it so easy to pick the correct part for my model fridge!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marlene from SCOTTSDALE, AZ
- Parts Used:
- FPPWFU01
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
I had a light come on and tell me I needed a new water filter
Pushed the old filter in and it came out then I pushed in the new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tim from SYLVANIA, OH
- Parts Used:
- 240597220
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
2 drawer undercounter beverage ref not getting cold enough. Wont get below 48°
Took drawers out by removing 2 screws on top of rail near front, then popped black plastic cover off in lower right inside cabinet...sensor just un plugged and new one plugged in easily...did not fix problem though...display set at 34 but bottom drawer reads about 40 at best and upper drawer reads around 55...dont think the 3 little fans inside on back wall have been running
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Debbie from Mount Juliet, TN
- Parts Used:
- 5303918899
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Freezer Cold, but Refrigerator not Cold
We replaced the damper, but it didn't fix the problem. We then purchased and replaced the thermistor. (We had previously replaced the defrost thermostat). The refrigerator side is now cooling better, but not enough. The damper doesn't seem to be opening. So we have now unplugged the damper and left the opening between the refrigerator propped open and the refrigerator side is now cool enough. (We had previously tried keeping the damper open before we replaced the thermistor and the refrigerator didn't cool off. So the thermistor did fix something, but the damper doesn't seem to have been the problem).
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jerome from Detroit, MI
- Parts Used:
- 241786014
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
Freezer door gasket became loose
Followed instructions for this part from this site and things went well.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Shellie from MONCKS CORNER, SC
- Parts Used:
- 241786014
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers
Freezer started icing up. Gasket was torn in places letting air in.
The most difficult task for me was getting old gasket out. I did call for repair help. The service person was most helpful. After almost giving up, one more tug and the gasket started coming out. Next step was cleaning the area. Aligning the gasket correctly made installation easier. I realized right away that I needed to start in a corner. The gasket went in without a hitch. My freezer is like new again. Next installment will be the refrigerator.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robin from SCOTTSVILLE, NY
- Parts Used:
- 5304536363
- Difficulty Level:
- Difficult
- Total Repair Time:
- Less than 15 mins
Wrong part sent twice
Every time I spoke to someone they sent wrong part . Still do not have correct part. Plus had to pay to return part. I sent model number , bin number and they can’t seem to match. Afraid to try again.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from ROCKINGHAM, VA
- Parts Used:
- FPPWFU01
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Replace Water filter Frigidaire Refrigerator
Followed the simple instructions on the device and in the appliance use and care manual
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jeffery from CATSKILL, NY
- Parts Used:
- 5304525957
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Socket set
During a recent move, they had to remove the doors, so they removed the top two door brackets.
The repair was quick and easy. Just install the ordered bracket ( hinge ) on the top refrigerator door and cover. I had all the screws and cover but somehow the original bracket was missing...hummm
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Avrum from Boynton Beach, FL
- Parts Used:
- 241786014
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
Had frost in freezer of side by side. Did dollar bill test and determined that gasket was not sealed.
Consulted You Tube. Took off old gasket. Easy. Put on new one after getting it warm. The track on the new gasket did not sit properly. Took multiple attempts but finally worked. Size was perfect but the gasket color was different than original and therefore, different from the refrigerator door. No tools required.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Susan from BRAINTREE, VT
- Parts Used:
- 218755402
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- 1- 2 hours
A set scew was ordered twice.
The first order arrived in a huge box and there was no scew to be found, the box had wholes in it. I was given a refund and told to order again.
The repair did not happen and the set screw which was actually recieved the second time was returned because it was the wrong size.
The repair did not happen and the set screw which was actually recieved the second time was returned because it was the wrong size.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- HARRY from S SAN FRAN, CA
- Parts Used:
- 241786014
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Freezer door seal shrunken,icing up,constant running
Pulled door seal put and pushed in new seal, icing formed on fridge side lower return vents, had to fully chip away, compressor running and stopping as normal.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nancy from LEHIGH ACRES, FL
- Parts Used:
- 218755504
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Wrench (Adjustable)
No problems
I had no problems. Screws arrived sooner than expected. It was a very simple installation. Very pleased with both the product and service.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jack from SILVER SPRING, MD
- Parts Used:
- 5304522314
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
bulb burned out
replaced bulb
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Russell from Lehigh Acres, FL
- Parts Used:
- 241786014
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
I noticed ice on the inside of freezer door
The young lady that helped me was fantastic... great product knowledge and affermed the correct and we got it ordered... Fast shippers and the install was easy although there were no instructions to be had... checking the gasket and removing the old one,,, it pressed in place in moments... They are booked marked and will use them the next time...
Was this instruction helpful to you?
Thank you for voting!