GRMS2773AF00 Frigidaire Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Marlene from SCOTTSDALE, AZ
- Parts Used:
- FPPWFU01
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
I had a light come on and tell me I needed a new water filter
Pushed the old filter in and it came out then I pushed in the new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from ROCKINGHAM, VA
- Parts Used:
- FPPWFU01
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Replace Water filter Frigidaire Refrigerator
Followed the simple instructions on the device and in the appliance use and care manual
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bruce from LAKEVILLE, MN
- Parts Used:
- 5304519044
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Missing door magnet for the open/close switch
Installed the magnet in the bracket on the bottom of the door.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from ORLANDO, FL
- Parts Used:
- 241829001
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
ICE WOULDN'T DISPENSE FROM ICE BOX
I read other suggestions trying isolate auger motor shaft with pliers while turning bar drive. needle nose pliers could hold the shaft. bar drive just would spin. so took the whole ice box assembly out
(only 2 screws) and with a metal cutting blade used the sawzall to cut along the shaft. freed it up enough to then unscrew it from that point. Left handed threads by the way.
(only 2 screws) and with a metal cutting blade used the sawzall to cut along the shaft. freed it up enough to then unscrew it from that point. Left handed threads by the way.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Margaret from WINDER, GA
- Parts Used:
- 5304508270
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
From day one the installer did not tighten the screw in the freezer handle. It finally came apart. They didn't leave me the Allen wrench for my fridge.
Simple tightening of the screw with the right tool.
Was this instruction helpful to you?
Thank you for voting!