Models
>
NS229NA
NS229NA Admiral Refrigerator
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for NS229NA
Viewing 1 of 1
Keep searches simple, eg. "belt" or "pump".
$15.26
This is an authentic OEM replacement part. This door shelf retainer is designed for use with refrigerators. There is one retainer on each side of the shelf holding the retaining bar in place. This rep...
On Order
This is a genuine OEM replacement part. This door shelf retainer bar is designed for use with refrigerators. This retainer bar is designed for and cut-to-fit the door shelf on the inside of your refri...
Special Order
$9.79
This is a genuine OEM replacement part. This egg tray is designed for use with refrigerators. This tray fits inside a compartment on the door of your refrigerator, and it holds up to fourteen eggs. T...
Special Order
This white door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.
No Longer Available
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- BettyJo from Culpeper, VA
- Parts Used:
- WP70111-108
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
door shelf retainer bars were broken
I received the door shelf bars. They were 26 inches. I used a hack saw and cut them to 22 inches. Put them on.
Perfect fit!!
Perfect fit!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary from Sodus, NY
- Parts Used:
- 70197-1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
needed clips to hold shelf on the door with
we ordered 2 clips and all we had to do is put the clips on the shelf to hold it . very easy!!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Versa J from Roseburg, OR
- Parts Used:
- WP70111-108
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
the previous one was broken
had to cut approximately 1/2 inch off. It was a bit to thick used the pliers to squeeze it to a thickness it would fit in the slots
Was this instruction helpful to you?
Thank you for voting!