JR3000V Makita Reciprocating Saw - Parts

This is a power cord, and it is used with several power tools. It is made of a thick rubber that is tough, and insulated for a long life. It has two 18 gauge wires, and is 8 feet long. When removing y...

If your motor is running poorly, running intermittently, it is likely in need of new carbon brushes. This part includes a set of two carbon brushes with wire leads and brush springs attached. Changing...

This is a cord guard, also known as a strain reliever, for your power tools. Power tool cords go through a lot of stress during usage, and this part is designed to remove some of that stress from the ...

This is a genuine Makita replacement part, it is sold individually. It is part of the blade holding assembly for the reciprocating saws shown below. It is threaded into the Blade Clamp, then on the op...

This is a Genuine OEM Makita replacement part, this part is sold individually. It is part of the blade clamping system for the specific Makita Reciprocating Saws. Only use the properly sized Hex Tool ...

This is genuine Makita replacement part, it is sold individually. This is part of the reciprocating blade holding assembly for the tools listed below. By looking at the parts diagrams of those tools y...

This is a self-tapping screw, and it is found on multiple power tools and lawn equipment. This screw is different because it can tap its own hole into tough materials, such as metals and hard plastics...

Included in Part Number 516306-1. rnThis Ball Bearing is sealed on both sides. This genuine Makita replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating par...

Genuine Makita replacement part, this item is sold individually. The part number 256701-0 is part of the blade clamp system on the Makita JR3000V Type 2.It was used to secure the blade clamp block to ...

This is a Trigger type switch that has internal terminals and a locking mechanism. This genuine Makita replacement part is sold individually. Switches are commonly replaced parts in power tools. A s...

This genuine OEM steel ball is found within the housing of your power tool. It serves as a detent mechanism, securing the shift knob in various positions to allow for the selection of different operat...

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it ha...