Models
>
PCG364ED
PCG364ED (06) Thermador Range
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by Apr 2
In Stock
Order now and your part arrives by Apr 2
In Stock
Order now and your part arrives by Apr 2
On Order
This potentiometer, also known as a spark ignition switch, sits behind a range or cooktop control knob and translates the rotation of the knob into electrical signals that regulate burner heat and ens...
In Stock
Order now and your part arrives by Apr 2
$208.21
This fixing kit provides the parts needed to install or replace your oven’s control board, which regulates heat and cooking functions. Compatible with select models, it’s a practical solution for rest...
In Stock
Order now and your part arrives by Apr 2
This surface burner cap is for ranges. Surface burner cap fits on top of the burner head. The burner cap protects the burner head from spills and helps spread out the burner flame for even heating.
No Longer Available
In Stock
Order now and your part arrives by Apr 2
In Stock
Order now and your part arrives by Apr 2
This burner base is for cooktops. Burner base holds the orifice and directs the gas to the burner head.
No Longer Available
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Robert from GREENWOOD VLG, CO
- Parts Used:
- 00629722
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Nutdriver, Socket set
Four extra Low burner igniters malfunctioned, Sparking when burner off.
The sole review for this part by Andrew was most helpful and accurate with one exception: he said that there were two nuts Which needed to be removed in order to pull off the front knob panel. There were actually two on each end for a total of four, which confused me, as I wondered if I had the right ones. Another thing that would be help
... Read more
ful for somebody considering doing this repair is to know that it takes a deep quarter inch socket With two 6 inch extensions to reach these nuts through holes in the interior side panels. Also, take a look at the replacement potentiometers, and you’ll see that there’s a slot that can be lined up so that they can be pulled off the side of the shaft rather than off the front of the shaft. This repair took me about six hours. I’m mechanically inclined and work methodically, but since I’ve never done this repair before it was quite time-consuming.
Read less
Was this instruction helpful to you?
Thank you for voting!