Models > 30-2662-00

30-2662-00 ((08)) Tappan Range

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$8.94
This round chrome drip pan contains a center hole of approximately four inches wide.
In Stock
Sold individually.
In Stock
When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner
In Stock
This flat style gas oven igniter comes with a bracket and wires. Its amperage range is between 3.2 and 3.6 amps.
In Stock
No Longer Available
This flat style gas oven igniter is 5.53 inches long and comes with a bracket and wire nuts. Its amperage range is between 3.2 and 3.6 amps. May be different in appearance but will function as the orginal part.
In Stock
No Longer Available
No Longer Available
No Longer Available
No Longer Available
No Longer Available
$34.69
Special Order

Questions and Answers

Be the first to ask our experts a question about this part!

Common Problems and Symptoms for 30-2662-00

Viewing 3 of 3
Gas igniter glows, but will not light
Fixed by these parts
Fixing Fixing
How to fix it
Little to no heat when broiling
Fixed by these parts
Fixing
How to fix it
Will Not Start
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Gregg from Naukati, AK
Parts Used:
5303935068
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
Ignitor burnt out
I removed the broiler burner assembly held in by 5 screws across the inside top of the oven, as I removed the assembly the igniter slid out from the back of the oven and was attached to the assembly with a cannon plug, I disconnected the cannon plug and removed the whole assembly out of the oven and replaced the igniter which was attached by two screws and reassembled in the oven. Where I live in remote Alaska calling a repair technician is not an option, either figure it out or have a new appliance barged in.
14 of 18 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Donald from Middle Village, NY
Parts Used:
316035200
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Two top burners would not light, defective switch
Warning- we found a lot of bare wires in this stove, check your wires before replacing the bad switches. I lifted the top, disconnected the power, pulled off the knobs, unscrewed the switch for the back light, removed seven screws to finally get the front panel off. Once you have the front panel off, changing the swich takes less than a m inute. The switches just slide off the gas valve stems. Instructions show how to line up the new D-shaped switch mechanism to match the D-shaped shaft. Gently pull the two wires off the old switch and slide onto the new switch. Then put the panel back.
12 of 14 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mariano from Torrance, CA
Parts Used:
5303131115, 316055800
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Very old burner grates & drip pans, need replacement.
Took out the old & easily replace it with the new set. No tools required.
14 of 21 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!