Models
>
NE63T8951SG
NE63T8951SG (AA) Samsung Range
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for NE63T8951SG
Viewing 1 of 1
Keep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by Aug 23
In Stock
Order now and your part arrives by Aug 23
This convection fan motor plays a key role in maintaining uniform heat distribution during convection cycles by rotating the fan blade to circulate hot air. A failing motor may result in uneven cookin...
In Stock
Order now and your part arrives by Aug 23
Special Order
In Stock
Order now and your part arrives by Aug 23
In Stock
Order now and your part arrives by Aug 23
This convection fan motor (part number DG31-00022A) is for ranges. Convection fan motor DG31-00022A spins the fan blade to circulate hot air through the oven for even heating. Unplug the range or shut...
In Stock
Order now and your part arrives by Aug 23
On Order
In Stock
Order now and your part arrives by Aug 23
In Stock
Order now and your part arrives by Aug 23
In Stock
Order now and your part arrives by Aug 23
Special Order
Common Problems and Symptoms for NE63T8951SG
Viewing 3 of 3No heat
Fixed by these parts
How to fix it
Doesn’t shut off
Fixed by these parts
How to fix it
Won’t turn on
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Raymond from TROY, OH
- Parts Used:
- 3405-001034
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
The microwave would not turn on or would run with the door open
Other tools that are usefull long needle nose pliers, long thin blade screw driver and small magnetic flashlight. Place the microwave on a work bench and remove the case it cover 3 sides. Place the microwave on a chair so it can stand with the controls up. You are replacing the lower door microswitch. The switch is located behind the
... Read more
control panel in the lower part of the area. The switch is several inches inside this area and your hands will not fit. Take care when moving wires and a couple of sensors. Use the thin blade screwdriver to release a tab holding the switch in place. Do not break this tab. Take the needle nose pliers and remove the switch. Put the wires on the new switch, open the door a short distance so a door lever moves enough to put the microswitch back into the bracket.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Judith from WASHINGTON, DC
- Parts Used:
- DG94-00550A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Slider Assembly in Oven Warming Drawer
Install handled by building engineer...thankfully. Did not take long for him, however, to install both sides of the drawer.
Was this instruction helpful to you?
Thank you for voting!