22RA-4K Magic Chef Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Frank from Pierce, ID
- Parts Used:
- Y8007P02060
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The grommets came apart metal from rubber.
I replaced the broken grommets with the new ones. I purchased 8 so I would have back ups because I did not feel the new one would last either. I think they cost TOO MUCH but I could not haggle for price.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michelle from Silver Springs, FL
- Parts Used:
- 74003106
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Needed a second oven rack for RV oven.
With a family of five a needed an extra oven rack as my RV oven is very small. After much aggravation between calling and going online to the manufacturer I still could not get any help. Even with locating the all important parts number. I was just about to give up when I was surfing around and found this website. Wow! What a relief! Not only did you show my where to find the part number, but I ordered it and got it within days. I spent more time on hold and online with the manufacturers customer service than anything else. From now on, no matter what I need, whether RV or home, I'm going staright to PartSelect. Thank You and my family thanks you too, as we wil be camping on Turkey Day and now I'll be able to get all the meal done at once! Happy Thanksgiving! God Bless
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- joseph from wildomar, CA
- Parts Used:
- Y8007P02060
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
range top loose, grommets missing
very easy to push each grommet into range top holes
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tom from Issaquah, WA
- Parts Used:
- 74001835, 3423F001-34, 12400029, 12400028
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers, Wrench (Adjustable)
Factory installed hinges were bent, preventing the oven door to close tightly
Had to turn off the propane, disconnect the propane line and then remove several screws holding the stove in the cabinet. Once I was able to pull the unit out of the cabinet, I had to remove several other screws for the sides in order to gain access to the hinge arm and spring. The front of the oven door had to be removed in order to get to the hinges. Replaced both left and right hinges, hinge arms and springs. After replacing all of the screws, I reinstalled the stove into the cabinet and reinstalled the screws securing it to the cabintet. Reconnected the gas line and checked for leaks. None found. Oven door operates properly now.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Randall from Rochester, NY
- Parts Used:
- WP74002414, 74002413
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
igniter would no longer work, it would stick
pull knob off streight out. remove two phillips head screws, disconnect wire to disassemble. To reassemble reattatch wire to replacement igniter, screw in two phillips head screws and push on the knob.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Pauline from Weedsport, NY
- Parts Used:
- 74003106
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Oven rack missing
Opened oven door, slid in rack , closed door...
Fit perfect....
Fit perfect....
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from Angleton, TX
- Parts Used:
- W10125661
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Socket set, Wrench (Adjustable)
Thermoset W/Flange , For The Oven
The fuel lines had to be cross over from the factory positions which made one 3/8" to short. Resolved problem by cutting the sheet metal on the back of the stove top from 1" hole to 1. 5" By cutting a slot in the lower protion of the hole which when bent down allowed me to rebend the fuel line down giving me the needed length to reconnect the fuel line. New thermoset/fuel valve work great upon completion. Sincerely john o. Bevers
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Hal from National City, CA
- Parts Used:
- Y8007P02060
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
missing gromet
Pushed into hole by hand, really simple
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tim from Prosser, WA
- Parts Used:
- 12001296
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Igniter wouldnt turn- knob spinning on shaft
Pull knob off igniter shaft, remove two screws, take out igniter, unplug wire. Reverse to install. Would have been very simple except the metal insert that is supposed to be inside the new knob was missing from the kit. I tried using the old insert in the new knob but it did not fit tight enough and would spin on the shaft. Had to use the old worn knob on the new igniter. Customer service said they don't carry the inserts. What? The brand new knob is useless! Needed to get the stove fixed so I didn't bother returning the entire kit. Oh well, stove works now!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Timothy from Vacaville, CA
- Parts Used:
- 12001296
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
igniter not working on magic chef stove on 60 foot yacht
called and ordered the part. it arrived the next day. amazing. put it in and all was well./ another happy yacht owner.
Tim Wiest
Tim Wiest yacht Service
Tim Wiest
Tim Wiest yacht Service
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Wendi from Cypress, CA
- Parts Used:
- 74003106
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
I needed an additional rack for our RV oven
After some research in finding the information under the range hood, I did internet searches to find the appropriate replacement rack.
It fits great and we are thrilled to have the additional rack.
It fits great and we are thrilled to have the additional rack.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jimmy from Texarkana, AR
- Parts Used:
- 74003106
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
oven rack missing
Odered rack on internet. Received in timely manner. Was the correct oven part. Very satisfied. Thank you.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dave from GOODLETTSVLLE, TN
- Parts Used:
- 12001296
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Generated no spark
Remove 2 screws and 1 wire reinstall same with new switch and knob
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William from ARCHER, FL
- Parts Used:
- 74002413
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Wouldn't ignite
Pulled knob,removed 2 screws removed wire,removed old ignitor repl. With new reversed procedure,done
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- DONNA from WARREN, PA
- Parts Used:
- WP74002414
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Old knob is broken
This item had to be returned. Didn"t fit. Our shaft is shorter, and the new knob would not stay on.
Was this instruction helpful to you?
Thank you for voting!