LRE30453SW (FW1LLGA) LG Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Charles from SARASOTA, FL
- Parts Used:
- 383EW1N006P
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Plastic cover on the control panel was cracking from high heat frying.
The two ribbon cables connecting the panel to the PC board slide into connectors on the PC board, these connectors have small tabs on each end that are pulled up to free the cable connection, then are pushed down to secure the new cable ends. Use a long Phillips bit on your screw gun to reach the screw at the bottom of the PC board.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from TRUMBULL, CT
- Parts Used:
- 5300W1R006A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Socket set
Glass heating element not working
Very easy.1: Shut power to stove.
2: Remove 3 hex screws from oven to range top at underside of top.
3: Raise to from front and disconnect multi- connector at right rear of top.
4: flip over top and demoed 4 screws on hold down strap at each side.
5: Remove element from under strap.
6: Disconnect element from wires./ remember where wires were connected. Connect multi connected from stove.
7: Replace strap and flip top, screw it back on, put power back on.
Only about 30 minutes even if you get a coffe break. Don’t even have to move stove.
2: Remove 3 hex screws from oven to range top at underside of top.
3: Raise to from front and disconnect multi- connector at right rear of top.
4: flip over top and demoed 4 screws on hold down strap at each side.
5: Remove element from under strap.
6: Disconnect element from wires./ remember where wires were connected. Connect multi connected from stove.
7: Replace strap and flip top, screw it back on, put power back on.
Only about 30 minutes even if you get a coffe break. Don’t even have to move stove.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Charles from Camden, AR
- Parts Used:
- EBR74632605
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Oven would not reach set operating temperature
Removed the back of the Range. Removed one wire at a time from the old PCB and placed it in position on the New PCB. Then secured the New PCB in the holder.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Denise from NORTH BEACH, MD
- Parts Used:
- 6930W1A003X
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Thermostat needed to be replaced
We had made this determination with the help of a repairman on the phone. I ordered the part and waited for it. It was stuck in West Virginia. After several days after it was expected a repairman fixed my range to the tune of $168. It should have cost $30 (the cost of the part and shipping).
Unfortunately I probably won't order from PartSelect again.
Unfortunately I probably won't order from PartSelect again.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- K R from BOISE, ID
- Parts Used:
- 4778W1N001B
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Broken front leveler
This is a very simple repair of remove and replace. You do have to lay down the range to make it easy.
Was this instruction helpful to you?
Thank you for voting!