LFRF0222 (AW2LLGA) LG Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Leonard from Plano, TX
- Parts Used:
- 6871W1N012B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Oven would initially start to heat up but would not hold its temp
I searched online and found someone that seemed to have the exact problem. That person had replaced the lower burner and the same PCB board I replaced. I was able to test the lower burner without removing it and it tested OK. The PCB board in the article I had checked was burned and obviously bad but mine was not. I took a chance and ordered just the PCB board. I replaced this board and the oven now works perfectly. I seems this board was not turning on the bottom burner but the system thought it was working fine.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from TRUMBULL, CT
- Parts Used:
- 5300W1R006A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Socket set
Glass heating element not working
Very easy.1: Shut power to stove.
2: Remove 3 hex screws from oven to range top at underside of top.
3: Raise to from front and disconnect multi- connector at right rear of top.
4: flip over top and demoed 4 screws on hold down strap at each side.
5: Remove element from under strap.
6: Disconnect element from wires./ remember where wires were connected. Connect multi connected from stove.
7: Replace strap and flip top, screw it back on, put power back on.
Only about 30 minutes even if you get a coffe break. Don’t even have to move stove.
2: Remove 3 hex screws from oven to range top at underside of top.
3: Raise to from front and disconnect multi- connector at right rear of top.
4: flip over top and demoed 4 screws on hold down strap at each side.
5: Remove element from under strap.
6: Disconnect element from wires./ remember where wires were connected. Connect multi connected from stove.
7: Replace strap and flip top, screw it back on, put power back on.
Only about 30 minutes even if you get a coffe break. Don’t even have to move stove.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Denise from NORTH BEACH, MD
- Parts Used:
- 6930W1A003X
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Thermostat needed to be replaced
We had made this determination with the help of a repairman on the phone. I ordered the part and waited for it. It was stuck in West Virginia. After several days after it was expected a repairman fixed my range to the tune of $168. It should have cost $30 (the cost of the part and shipping).
Unfortunately I probably won't order from PartSelect again.
Unfortunately I probably won't order from PartSelect again.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- K R from BOISE, ID
- Parts Used:
- 4778W1N001B
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Broken front leveler
This is a very simple repair of remove and replace. You do have to lay down the range to make it easy.
Was this instruction helpful to you?
Thank you for voting!