Models
>
WDES9428F
WDES9428F (00) LG Range
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$76.42
If your appliance isn’t heating or cooling the way it should, this temperature sensor might be the issue. Also known as a thermistor, it helps your appliance stay at the right temperature by working w...
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
Special Order
On Order
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
Special Order
$107.20
This gasket packing is a replacement sealing material designed to create a tight barrier between surfaces. It is commonly replaced when seals wear out, compress, or no longer prevent leaks.
In Stock
Order now and your part arrives by May 4
Common Problems and Symptoms for WDES9428F
Viewing 4 of 4Little to no heat when baking
Fixed by these parts
How to fix it
Oven not heating evenly
Fixed by these parts
How to fix it
Element will not heat
Fixed by these parts
How to fix it
Oven is too hot
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Barry from PIERRE, SD
- Parts Used:
- EAU62343001
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers
Convection Fan stopped working, would spin but not continuously on its own
Unplugged oven electric and turned gas off. Removed all back covers from the unit. Removed the cover on the inside covering the burner and fan in the back of the convection oven. Removed the nut securing the fan to motor shaft with helper holding the motor. Removed the three electrical wires attached to motor, making note where they go.
... Read more
Removed screws mounting the motor to oven. Removed motor cooling fan and shaft spacer from old motor. Fit in same orientation on new motor. Replace all parts in reverse order, restore gas and electric, turn on and test.
Read less
Was this instruction helpful to you?
Thank you for voting!