LSEL6335F (00) LG Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Barry from PIERRE, SD
- Parts Used:
- EAU62343001
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers
Convection Fan stopped working, would spin but not continuously on its own
Unplugged oven electric and turned gas off. Removed all back covers from the unit. Removed the cover on the inside covering the burner and fan in the back of the convection oven. Removed the nut securing the fan to motor shaft with helper holding the motor. Removed the three electrical wires attached to motor, making note where they go. Removed screws mounting the motor to oven. Removed motor cooling fan and shaft spacer from old motor. Fit in same orientation on new motor. Replace all parts in reverse order, restore gas and electric, turn on and test.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from CHESAPEAKE, VA
- Parts Used:
- MEE62385201
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Hammer 1, Glass range top and heating element 0
Dropped a hammer on the range while removing a ceiling light. Viewed a How-To video on Google. Ordered the needed parts. Followed the steps from the How-To video. Reinstall was a bit tricky by myself - could have used an extra set of hands. I have a few words of caution:
1) Put something between the range top and range - like a sheet or drop cloth - to prevent a dropped screw from falling into a crevice in the stove. I dropped a screw and was unable to retrieve it, even with a magnet.
2) Makes sure you remove all bumpers, screws, clips, etc. from the item being replaced and put them on the new item if the new item does not come with replacement bumpers, screws, etc.
1) Put something between the range top and range - like a sheet or drop cloth - to prevent a dropped screw from falling into a crevice in the stove. I dropped a screw and was unable to retrieve it, even with a magnet.
2) Makes sure you remove all bumpers, screws, clips, etc. from the item being replaced and put them on the new item if the new item does not come with replacement bumpers, screws, etc.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Glenn from NEWLAND, NC
- Parts Used:
- EBG51439305
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers
LG electric range completely shut down at end of oven cleaning cycle.
Trouble shooting took much longer than repair. Not obvious but a flow diagram in the LG service manual pointed towards a defective bimetal thermostat switch on the range inner back wall. The switch contacts tested bad when cold and this condition locks up the power module board to where it does not supply any DC power to the master controller board - thereby shutting down all oven operations. Thermostat is accessed after removal of the back panel via mounting screws plus removal/re-attaching unit spade lugs (needle nose pliers) plus removing/replacing the thermostat via one mounting screw. Phillip screw driver needed for panel access and thermostat disconnect. While I did in the course of troubleshooting, there is no real need to remove the oven top unit. Very inexpensive repair.
Was this instruction helpful to you?
Thank you for voting!