LSC5683WB (ABKLLCA) LG Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Dennis from CARY, IL
- Parts Used:
- MEE36593201
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
No heat in oven mode
Verified P/N with LG. Took a few days . They sent names of several suppliers, cost was almost double. Ordered part from P/S, here in 2 days. Watched video on you tube. Unplugged, took off back, unplugged bake element, removed power box. The opening for bake element is still attached to rear panel by tiny bits of sheet metal. Used Dremel with cut-off wheel to cut thru nibs & deburr opening. this panel has to be removed, it rests on bottom panel & is held in position by power box. Removed bake element carefully, front of element broken, tried to put new element in, would not fit. Had to grind notches in bottom panel down to clear supports on new element. This did the trick. back together quick & no problems. If had to do again estimate less than 1 hour.. By the way am 81 yrs. young.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from MILWAUKEE, WI
- Parts Used:
- 5300W1R005A
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
wouldn't turn on
simply take picture b4 you start then replace same way.
WARNING!!! MAKE SURE YOU HAVE RIGHT PART!! They are very slow to return any type of credit
WARNING!!! MAKE SURE YOU HAVE RIGHT PART!! They are very slow to return any type of credit
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Charles from Camden, AR
- Parts Used:
- EBR74632605
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Oven would not reach set operating temperature
Removed the back of the Range. Removed one wire at a time from the old PCB and placed it in position on the New PCB. Then secured the New PCB in the holder.
Was this instruction helpful to you?
Thank you for voting!